Setting up your projector (continued)
Front projection, ceiling mounting
For ceiling mounting,
you need the ceiling
mount kit designed for
this projector. Ask a
specialist for installation.
For details, consult your
dealer.
•
The warranty on this projector does not cover any
damage caused by use of any non-recommended
ceiling mount kit or installation of the ceiling mount
kit in an improper location.
•
When using the projector mounted on the ceiling,
set IMAGE REVERSE in the INSTALLATION menu
to MIRROR INVERT. See page 7.
•
When the projector is mounted on the ceiling,
images may appear darker than those projected in
the case of tabletop mounting. This isn't a product
malfunction.
•
Ask your installation specialist to provide an A/C
power switch. When you do not use the projector, be
sure to shut down the main power by the switch.
•
Do not install the projector where the exhaust vents
are exposed to air emitted by an air conditioning.
Such installation may cause a breakdown.
•
Do not install the projector near a fire alarm
because it emits hot air from its exhaust vents.
Rear projection
Ask a specialist for
installation. For details,
consult your dealer.
•
For rear projection,
set IMAGE
REVERSE in the
INSTALLATION
menu to MIRROR. See page 7.
Caution:
•
Placing the projector directly on a carpet impairs
ventilation by the fans, causing damage or failure.
Put a hard board under the projector to facilitate
ventilation.
•
Place the projector at least 50 cm (or 0 inch)
away from the wall to prevent the air inlet grille
and the air outlet grilles that emit hot air from
being blocked.
•
Do not use the projector in the following locations
and manners, which may cause fire or electric
shock.
•
In a dusty or humid place.
•
In a sideways position, or with the lens facing
down.
•
Near a heater.
•
In an oily, smoky, or damp place such as a kitchen.
•
In direct sunlight.
•
Where the temperature rises high, such as in
a closed car.
•
Where the temperature is lower than +41°F
(or +5°C) or higher than +95°F (or +5°C ).
Important:
•
Do not apply force to the lens, because the lens may
be damaged.
•
Be sure to use this projector at an altitude of less than
1500 meters.
TRIGGER terminal
The TRIGGER terminal on the rear of the projector
is a terminal that outputs a 1 V signal to control an
externally connected device (electric screen) when
images are projected.
(Ground 0 V)
To use the TRIGGER terminal, set TRIGGER OUT
to SCREEN or ANAMORPHIC in the INSTALLATION
menu. (The factory default is OFF. See page 7 for
details.) Use the following steps to change the setting.
With the INSTALLATION menu:
(See page 6 for menu setting.)
1.
Display the INSTALLATION menu.
.
Select TRIGGER OUT by pressing the p or q
button.
.
Select SCREEN or ANAMORPHIC by pressing the
t or u button.
To cancel the menu:
4.
Press the MENU button.
Caution:
•
Do not use the signal output from the TRIGGER
terminal as a power for other devices.
•
Do not link the TRIGGER terminal with an audio
terminal of other device because that device may be
damaged.
•
The rated current for the TRIGGER terminal is
00 mA. If you use a current exceeding this rating, a
failure may occur.
•
For information about electric screens, please
contact screen manufacturers.
EN-1
TRIGGER
To externally
connected device
Ring (NC)
Tip (1 V)