installation & maintenance
WATER SUPPLY CONNECTOR FILTER
1. Pull out the filter and wash well.
2. Pull in the filter and connect the hose to the inlet water valve
tightly.
3. Check if there is a leakage.
Note to tighten up the connector.
CLEANING THE FILTER
Clean the filter net often to keep the washer clean.
1. Push the upper part of the Hygiene filter
and pull in.
3. Clean the Hygiene filter.
CLEANING THE PUMP FILTER (OPTION)
1. Place a rag or towel under the wash filter to avoid wetting the floor, and rotate the filter counterclockwise
and pull it out.
2. Remove any dirt from the filter.
3. Return the filter to its place by rotating the filter clockwise until it locks into position.
1
CLEANING THE DETERGENT COMPARTMENT
1. Separate the detergent compartment from the washer.
2. Separate and clean the Rinse-Cap from the detergent compartment.
3. Assemble the Rinse-Cap and insert the detergent compartment into the washer.
20_installation & maintenance
WA13GPBIC-02962C-01_EN.indd 20
2. Open the cover as shown in the figure.
4. Close the cover and insert the lower part of
the filter in the basket first and then push
the filter with "click" sound.
2
3
2011-09-15
12:00:14