Advertisement
Available languages
Available languages
Mechanical safety characteristics, hazards
• The appliance does not have sharp edges or protruding parts. The
guards for the moving and live parts are fixed to the cabinet with screws,
to prevent accidental access.
Protection devices installed on the machine
• The guards on the machine are:
– fixed guards (e. g. casings, covers, side panels, etc.), fixed to the
machine and/or frame with screws or quick-release connectors that
can only be removed or opened with tools;
A A . . 5 5 T T r r a a n n s s p p o o r r t t , , h h a a n n d d l l i i n n g g a a n n d d s s t t o o r r a a g g e e
• Due to their size, the machines can be stacked on top of each other
during transport, handling and storage by complying with that specified
on the slip placed on the packing.
• Do not stand under suspended loads during loading/unloading
operations. Unauthorised personnel must not enter the work area.
• The weight of the appliance alone is not sufficient to keep it steady.
• For machine lifting and anchoring, do not use movable or weak parts
such as: casing, electrical raceways, pneumatic parts, etc.
• Do not push or pull the appliance to move it, as it may tip over.
• Machine transport, handling and storage personnel must be
adequately instructed and trained regarding the use of lifting systems
and personal protection equipment suitable for the type of operation
carried out (e.g. overalls, safety shoes, gloves and helmet).
• When removing the anchoring systems, make sure the stability of the
machine parts does not depend on the anchoring and, therefore, that
this operation does not cause the load to fall off the vehicle. Before
unloading the machine components, make sure all the anchoring
systems are removed.
• Machine positioning, installation and disassembly must be carried out
by specialised personnel.
A A . . 6 6 I I n n s s t t a a l l l l a a t t i i o o n n a a n n d d a a s s s s e e m m b b l l y y
• The operations described must be carried out by personnel qualified
(refer to D.1 Characteristics of personnel trained for normal machine
use ) in compliance with the current safety regulations, regarding the
equipment used and the operating procedures.
• The plug, if present, must be accessible after positioning the appliance
in the place of installation.
• Disconnect the appliance from the power supply before carrying out
any installation procedure.
9
Advertisement
