Table of Contents
Advertisement
3
Faults and what to do
about them.
Emergency release
F a u l t s a n d w h a t t o d o a b o u t t h e m .
e.g. in the event of a power cut
The programme will continue running
when the power supply has been
restored.
However, if the laundry has to be
removed, the washing machine door
can be opened as follows:
:
Warning
Risk of scalding!
When you are washing at high
temperatures, there is a risk of scalding
if you come into contact with detergent
solution and laundry.
If possible, leave it to cool down.
:
Warning
Risk of injury!
You may injure your hands if you reach
into the drum while it is turning.
Do not reach into the drum when it is
turning.
Information on the display panel
Display
YES
NO
¼ flashes
E:17
Cause/remedial action
The washing machine door is unlocked. It is possible to add laundry.
The temperature is too high. Wait until the temperature falls.
■
Water level too high. Not possible to add laundry. If necessary, close the wash-
■
ing machine door immediately. To continue the programme, press Start/Pause
A.
Laundry may be caught. Please open and close the washing machine door
■
again and press Start/Pause A.
If necessary, push the washing machine door closed or remove the laundry and
■
push it closed again.
If necessary, switch the appliance off and on again; set the programme and
■
make your individual settings; start the programme.
Turn the water tap on fully,
■
The supply hose is kinked/trapped,
■
The water pressure is too low. Clean the filter.
■
Faults and what to do about them.
Wait until the drum has stopped turning.
Caution!
Water damage
Any escaping water may cause water
damage.
Do not open the washing machine door
if water can be seen through the glass.
Switch off the appliance. Disconnect
1.
the mains plug.
Drain the detergent solution
2.
Pull the emergency release
3.
downwards with a tool and release.
The washing machine door can then
be opened.
en
.
27
Advertisement
Table of Contents
