Table of Contents
Advertisement
30
USER SETTINGS
Display
1
To view the oSD menu, press the Joystick button on the
bottom of the monitor and then enter the Menu.
2
Go to Screen > Display by moving the joystick.
3
Configure the options following the instructions that appear in
the bottom right corner.
4
If you want to configure an upper menu, or another option,
move the joystick ◄ or press it (
5
If you want to exit the OSD menu, move the joystick
you exit.
Each option is described below.
Menu > Screen > Display
Horizontal
Vertical
clock
Phase
NoTE
This function is activated only when using D-Sub analog input.
y
(When using analog signals, this function is required because the position and focus of the video
varies slightly according to graphic cards, cables, resolution settings, etc. This function is not re-
quired when using digital signals.)
Use the Menu > Auto Configuration (
y
focus.
/ OK).
Used to adjust the horizontal position of the screen.
Used to adjust the vertical position of the screen.
To obtain the correct width of the input signal by adjusting the frequency. Used to minimize
the vertical bars that appear because of an incorrect width.
Used to optimize screen performance by adjusting the phase.
) function to automatically obtain the optimal position and
Screen
Picture
Easy control
color
Display
function
Screen
Settings
until
◄
auto
configuration
Reset
▲ / ▼ : Move
Description
>
>
>
◄ : Back
/ ► : OK
Advertisement
Table of Contents
