Advertisement
Components
•
Stainless Steel Drinking Fountain
•
Stainless Steel Fixing Bracket
•
Security Screws and bit
Components supplied by others
•
Floor Anchors
•
40mm trap
Hydraulic Requirements
Pressure:
Min: 200kPa
Max: 500kPa
Inlet Connection:
G½B inlet connection
Outlet Connection:
40mm BSP Waste connection
Water Temperature:
4 - 30oC
Pre-Installation
Installation should be in accordance with AS/NZS 3500.1 & AS/NZS 3500.2, local authority and statutory requirements,
and as per these installation instructions.
1. Water and waste supply should be provided through the floor in the locations shown on the drawing.
2. Water should be able to be isolated from inside the unit and be flushed prior to connections
3. 40mm trap on waste [by others]
Installation
1. Remove the access panel from the unit using the security bit provided.
2. Mark the fixing holes in the base of the unit. Remove the unit, drill the floor, fit floor anchors [by others]
and re-fit the unit.
3. Ensure that the unit is secured
4. Flush lines
5. Fitt to the frame and make the necessary water and waste connections.
6. Check for leaks and replace the access panel.
Note: Bubbler will not tolerate dirt or grit and will not shut off if contaminated
2 of 4
INSTALLATION, OPERATION AND MAINTENANCE INSTRUCTIONS
SYDNEY | MELBOURNE | BRISBANE | PERTH | AUCKLAND
Australia 1300 788 778 www.rba.com.au | New Zealand 0800 722 111 www.rbagroup.co.nz
Advertisement
