Contents 1 Important Safety Notice 2 Your CD Soundmachine Introduction What's in the box Overview of the main unit 3 Get started Connect power Turn on Turn off 4 Play Play a CD Play from USB devices Tune to FM radio stations Play from Bluetooth-enabled devices Play from an external device 5 Play options...
1 Important • Batteries (battery pack or batteries installed) shall not be exposed to excessive heat such as sunshine, fire or the like. • CAUTION: Danger of explosion if battery is incorrectly replaced. Replace only with the same or equivalent type. Safety • The unit shall not be exposed to dripping or splashing.
This equipment should not be used for such Notice purposes. Any changes or modifications made to this device that are not expressly approved by WOOX Innovations may void the user’s authority to operate the equipment. The USB-IF Logos are trademarks of Universal Serial Bus Implementers Forum, Inc. Care of the environment Disposal of your old product The Bluetooth®...
2 Your CD Soundmachine Introduction With this CD Soundmachine, you can: • Listen to FM radio; • Enjoy audio from discs, USB device, Bluetooth devices, and other external audio devices; • Program the play sequence of tracks. What's in the box Check and identify the contents of the package: •...
Overview of the main unit CD/USB BT FM OFF a CD/USB source selector • Skip to the previous or next track. • Press to select CD or USB source. • Search within a track. e OPEN•CLOSE • Stop playing. • Open or close the disc compartment. c - ALBUM + f Bluetooth indicator • Skip to the previous or next album.
Page 8
/PAIRING • Start or pause play. • Press to wake up the unit from standby mode. • Press and hold to disconnect the connected Bluetooth device and enter pairing mode. h PROG • Program the play sequence of tracks. i MODE • Select a play mode.
Always follow the instructions in this chapter in sequence. Option 2: Battery power If you contact Philips, you will be asked for the model and serial number of your apparatus. The Caution model number and serial number are on the bottom of your apparatus.
Turn on Switch the source selector to CD/USB/BT/FM. Switch to standby mode • The product switches to standby mode automatically when there is no audio detected for over 15 minutes. • Press to wake up the product from standby mode. Turn off Switch the source selector on the product to OFF.
4 Play Play from USB devices Note • Make sure that the USB device contains playable audio content. Play a CD Switch the source selector to CD/USB . Note Press the CD/USB button on the top • You cannot play CDs encoded with copyright of the CD sound machine repeatedly to protection technologies.
• For optimal reception, fully extend and adjust the (refer to the user manual of the device). position of the FM antenna. Select [Philips AZ330T] on your device for pairing. If necessary, enter default password Switch the source selector to FM. “0000”. » After successful pairing and connection, Rotate + TUNING - to select a station.
Play from an external device You can also listen to an external audio device through this unit. Switch the source selector to CD/ USB/BT/FM. Connect an audio cable (3.5mm, not supplied) to: • the AUDIO-IN socket on the unit. • the headphone socket on an external device.
5 Play options Press to stop playback. Press PROG to activate the program mode. » [PROG] (program) begin to blink. Press to select a track number, then press PROG to confirm. Control play Repeat steps 3 to program more tracks. In CD and USB mode, you can control play Press to play the programmed tracks.
6 Product Total Harmonic Distortion <3% Signal to Noise Ratio >50 dBA information Bluetooth Note Bluetooth Version V3.0 + EDR Range 10 m (Free space) • Product information is subject to change without prior Bluetooth Frequency 2.402GHz ~ 2.48GHz notice. Band General Specifications Power supply 110V~, 60 Hz;...
• Empty albums: an empty album is an accumulate at the disc lens. To ensure good album that does not contain MP3/ play quality, clean the disc lens with Philips WMA files, and is not be shown in the CD lens cleaner or any commercially display.
Refer to the user manual of the device, check the following points before device for how to enable the function. requesting service. If the problem remains unsolved, go to the Philips Web page (www. • This product is already connected with philips.com/support). When you contact Philips, another Bluetooth-enabled device.