Table of Contents
Advertisement
GENERAL INSTALLATION DATA
This equipment is designed and sold for commercial use only by personnel trained and experienced in
its operation and is not sold for consumer use in and around the home nor for use directly by the general
public in food service locations.
CAUTION
Before using your new equipment, read and understand all the instructions & labels associated with the
unit prior to putting it into operation. Make sure all people associated with its use understand the units
operation & safety before they use the unit.
All shipping containers should be checked for freight damage both visible and concealed. This unit has
been tested and carefully packaged to insure delivery of your unit in perfect condition. If equipment is
received in damaged condition, either apparent or concealed, a claim must be made with the delivering
carrier.
Concealed damage or loss - if damage or loss is not apparent until after equipment is unpacked, a
request for inspection of concealed damage must be made with carrier within 15 days. Be certain to
retain all contents plus external and internal packaging materials for inspection. The carrier will make
an inspection and will supply necessary claim forms.
WARNING: Improper installation, adjustment, alteration, service or
maintenance can cause property damage, injury or death. Read the
installation, operating and maintenance instructions thoroughly before
installing or servicing the equipment.
This fryer is equipped for the voltage and wattage indicated on the nameplate mounted on the underside
of the front edge. It is designed for use on alternating current (AC) only. It is intended for use by properly
trained personnel only.
DO NOT CONNECT TO DIRECT CURRENT (DC)
WARNING
The installation of the appliance should conform to the:
NATIONAL ELECTRIC CODE AND ALL LOCAL ELECTRIC CODES AND
ORDINANCES AND THE LOCAL ELECTRIC COMPANY RULES AND
REGULATIONS.
Proper connections and power supply are essential for efficient performance. Connect six foot lead in
cord to a suitable grounded outlet of the correct voltage. Be sure the switch is in the off position. The
receptacle should match the plug (NEMA configuration of receptacle is: 6-30R). Four legs are provided
and should be installed for ease of cleaning. Level unit by adjusting the (4) feet which have an adjustment
of 1-3/8" (35 mm) for accurate leveling and perfect line-up with other units.
POWER SUPPLY
The Model 301HLDS is wired at the factory for operation on a single phase power supply 208/240V, 60 Hz.
DO NOT INSTALL WITHOUT FEET PROVIDED.
PLACE THE LAMINATED WARNING SIGN SUPPLIED WITH THE FRYER IN AN
CAUTION
AREA VISIBLE TO THE FRYER OPERATOR.
Advertisement
Table of Contents
