Denver Electronics CR-419 MK2 Operating Instructions Manual page 4

LOCATION OF CONTROLS
5
4
3
2
1
1. ALARM 2/VOLUME+ BUTTON
2. ALARM 1/VOLUME- BUTTON
3. TIME SET/ SLEEP SET BUTTON
4. PRESET BUTTON
5. SPEAKER
6. SNOOZE BUTTON
7. MEMORY BUTTON
UNIT POWER SUPPLY
This unit is designed to operate with AC/DC 5V Adaptor.
Insert the small plug of adaptor into the DC Jack.
Insert the AC/DC adaptor into any convenient having 230-240V~AC, 50Hz household outlet in
vertical or horizontal direction.
TO SET THE TIME
Long Press TIME SET/ SLEEP SET button to trigger TIME SET MODE and display will start
blinking. Press the REVERSE/HOUR button to set the Hour and the FORWARD/MINUTE button
to set the Minute.
NOTES:
• Keep pressing the REVERSE/HOUR button or the FORWARD/MINUTE button if you run past
the correct time.
• Time is displayed in 24 hours mode.
TO SET THE ALARM
When device is "STANDBY OFF" mode,
• Press ALARM 1/VOLUME- button to turn Alarm 1 on or off. This is indicated by the Light
next to the Alarm 1 in display.
• Long press ALARM 1/VOLUME- button to set alarm 1's time. When the time display is
blinking after the long press, press the REVERSE/HOUR button to set the HOUR and the
FORWARD/MINUTE button to set the MINUTE.
Note: This is the same as setting up Alarm 2.
6
11
7
8
9
12
10
8. OFF/ON SWITCH
9. FORWARD/MINUTE BUTTON
10. REVERSE/HOUR BUTTON
11. LED DISPLAY
12. DC JACK
13. ANTENNA
14. BACKUP BATTERY COMPARTMENT
ENG-4
14
13