Other Connections; Remote Control - LG 40LH5710 Owner's Manual

NOTE
• To improve the picture quality in a poor signal
area, purchase a signal amplifier.
• Use a signal splitter to use 2 TVs or more.
• If the antenna is not installed properly, contact
your dealer for assistance.
• DTV Audio Supported Codec (Depending upon
country) : MPEG, AAC, HE-AAC, Dolby Digital,
Dolby Digital Plus
• Direct ULTRA HD broadcast is unavailable in
areas without an ULTRA HD signal.
• This TV cannot receive ULTRA HD (3840 x 2160
pixels) broadcasts directly because the related
standards have not been confirmed.
(Depending upon model)

Other Connections

Connect your TV to external devices. For the best
picture and audio quality, connect the external
device and the TV with the HDMI cable.
NOTE
• HDMI Audio Supported Format:
DTS (44.1 kHz / 48 kHz),
AC3 (32 kHz / 44.1 kHz / 48 kHz),
PCM (32 kHz / 44.1 kHz / 48 kHz / 96 kHz / 192
kHz) (Depending upon model)

Remote Control

(Image shown may differ from your TV.)
The descriptions in this manual are based on
the buttons on the remote control. Please read
this manual carefully and use the TV correctly. To
install batteries, open the battery cover, replace
batteries (1.5 V AAA) matching the
to the label inside the compartment, and close
the battery cover. Failure to match the correct
polarities of the battery may cause the battery
to burst or leak, resulting in fire, personal injury,
or ambient pollution. To remove the batteries,
perform the installation actions in reverse. This
remote uses infrared light. When in use, it should
be pointed in the direction of the TV's remote
sensor.
10
A
Toggles between Radio, TV, CATV, and DTV.
digital mode.
program.
Turns the TV on if it is off.
Number button Enters numbers.
(Dash) Inserts a dash between numbers such as
2-1 and 2-2.
selected (pressing repeatedly).
and ends
time scheduler.
A
(Power) Turns the TV on or off.
Returns to the last TV channel.
Activates your preferred subtitle in
Activates or deactivates the subtitles.
Resizes an image.
Shows information on the current
(Input) Changes the input source.
Accesses the saved channel list.
Alternates between the two last channels
Adjusts the volume level.
Accesses your favorite channel list.
Displays the program event according to
(Mute) Mutes all sounds.
Scrolls through the saved channels.
Moves to the previous or next screen.