Unitronics Jazz JZ20-J-R16HS Installation Manual

Jazz™PLC+HMI
JZ20-R10/JZ20-J-R10
JZ20-R16/JZ20-J-R16
JZ20-J-R16HS
 Before using this product, the user must read and understand this document.
 For additional information regarding this product, refer to the user guide and technical specifications.
 All examples and diagrams are intended to aid understanding, and do not guarantee operation.
Unitronics accepts no responsibility for actual use of this product based on these examples.
 Please dispose of this product according to local and national standards and regulations.
 Only qualified service personnel should open this device or carry out repairs.
Failure to comply with appropriate safety guidelines can cause severe injury or property damage.
 Do not attempt to use this device with parameters that exceed permissible levels.
 To avoid damaging the system, do not connect/disconnect the device when power is on.
Environmental Considerations
 Do not install in areas with: excessive or conductive dust, corrosive or flammable gas,
moisture or rain, excessive heat, regular impact shocks or excessive vibration.
 Ventilation: 10mm space required between the PLC+HMIs' top/bottom edges & enclosure
walls.
 Do not place in water or let water leak onto the unit.
 Do not allow debris to fall inside the unit during installation.
Mounting
Dimensions
* Note that for JZ20-J modules those dimensions are 7.5 mm (0.295").
Unitronics
Micro-PLC+HMI Installation Guide

6 Digital Inputs including 2 HSC, 4 Relay Outputs

6 Digital Inputs including 2 HSC, 2 Analog/Digital Inputs,
2 Analog Inputs, 6 Relay Outputs

6 Digital Inputs including 3 HSC/Shaft-encoder,
2 Analog/Digital Inputs, 2 Analog Inputs, 6 Relay Outputs
1