Advertisement
Available languages
Available languages
Table of Contents
Tester
User manual p.1
Notice d'utilisation p.3
This Tester is designed to be used with the Geemarc CLEARSOUND
products. Some of other products can not fully works.
Ce Tester est prévu pour fonctionner avec les produits de la gamme
Geemarc CLEARSOUND. Certains autres téléphones peuvent ne pas
fonctionner.
Installation :
- Plug the power cable into the power socket on the rear of the base.
- Plug the adaptor into the mains supply (*).
- Connect the first line cord plug to the line socket of the telephone 1.
(Only use the telephone line provided)
- Connect the other end of the line cord plug to the line socket 1 on the rear
of the Tester.
- Connect the second line cord plug to the line socket of the telephone 2.
- Connect the other end of the line cord plug to the line socket 2 on the rear
of the Tester.
Now your system is ready to be used.
Using :
With 2 telephones connected:
Lift one handset, now you have the following possibilities :
- Press the 1 button of the telephone to do the second telephone ring.
- Press the 2 button of the telephone to hear the busy tonality.
- Press the 3 button of the telephone to hear the audio input if connected.
- Press
to do ringing alternatively the two telephones.
Note:
- You have also the possibility to plug just one telephone.
- To connect an audio input use a cable with a 3.5mm plug connected on the
"AUDIO IN" on the rear Tester. You can use a CD player or other any other
musical source.
1
Advertisement
Table of Contents
Summary of Contents for Geemarc Line Simulator
- Page 1 Tester User manual p.1 Notice d’utilisation p.3 This Tester is designed to be used with the Geemarc CLEARSOUND products. Some of other products can not fully works. Ce Tester est prévu pour fonctionner avec les produits de la gamme Geemarc CLEARSOUND. Certains autres téléphones peuvent ne pas fonctionner.
- Page 2 Please note: The guarantee applies to the United Kingdom only. Declaration : Hereby Geemarc Telecom SA declares that this product is in compliance with the essential requirements and other relevant provisions of the Radio and Telecommunications Terminal Equipment Directive 1999/5/EEC and in particular article 3 section 1a, 1b and section Recycling directives WEEE When this product is out of order, please do not put it in your domestic waste bin.
- Page 3 Installation : - Branchez le cordon de l’adaptateur secteur à l’arrière du Tester. - Branchez l’adaptateur secteur (*). - Branchez le premier cordon PTT au téléphone 1. (Utilisez uniquement le cordon de ligne fourni) - Branchez l’autre extrémité de ce cordon dans la prise téléphone 1 à l’arrière du Tester.
- Page 4 Normalement votre Tester est configuré pour être utilisé en France, si vous voulez l’utililser dans un autre pays ou changer certains paramètres, reportez-vous au tableau ci-dessous pour le réglage : Fontion Specification Réglage des interrupteurs (Situés à l’arrière du Tester) Atténuation des lignes 1 &...
Need help?
Do you have a question about the Line Simulator and is the answer not in the manual?
Questions and answers