Panasonic VIERA TC-P55VT50 Manual page 9

■
Assembling the pedestal
Insert the protrusion of the Neck
into the Base firmly.
Neck
Protrusion of the
Neck (bottom)
Attach the Bracket to the protrusion
of Neck. Make sure that the bracket
is anchored before fixing the screws.
Fix securely with assembly screws.
(4 screws)
Protrusion of Neck (top)
Bracket
■
Set-up
Tighten assembly screws
then tighten them firmly to fix securely.
Arrow
mark
B x 4 pcs.
Base
(Image) Work on a flat surface
Warning
Do not disassemble or modify the pedestal.
Otherwise, the TV may fall over and become damaged, and personal injury may result.
Caution
Do not use any pedestal other than that provided with this TV.
Otherwise, the TV may fall over and become damaged, and personal injury may result.
Do not use the pedestal if it becomes warped or physically damaged.
If you use the pedestal when it is physically damaged, personal injury may result. Contact your nearest Panasonic Dealer immediately.
During set-up, make sure that all screws are securely tightened.
If sufficient care is not taken to ensure screws are properly tightened during assembly, the pedestal will not be strong
enough to support the TV, and it might fall over and become damaged, and personal injury may result.
When removing the pedestal, do not remove the pedestal by any methods other than the specified procedure. (Above)
Otherwise, the TV and/or pedestal may fall over and become damaged, and personal injury may result.
Attaching the pedestal to TV
Turn the stand over and fix stand neck
securely with assembly screws. (4 screws)
• Do not hold the neck when turning over
the stand.
Front
Front
Back of Stand
Attach the cover and fix securely with
assembly screw.
B x 4 pcs.
(total 4 screws) loosely at first,
Rear side
Hole for pedestal
installation
Bracket
B x 4 pcs.
Hole for screw
A x 1 pcs.
Cover
Removing the pedestal from the TV
Be sure to remove the pedestal in the following way when
using the wall-hanging bracket or repacking the TV.
Remove the assembly screws
Lift the TV from the pedestal.
Remove the assembly screw
Pull out the cover.
Remove the assembly screws
Remove the assembly screws
stand and pull out the neck.
Accessories
Assembly screws
A
XYN4+F10FNK (Black)
size (M4 x 10) (1)
B
XYN5+F16FN (silver)
size (M5 x 16) (12)
Bracket (1)
TBL5ZA3200
Neck (1)
TXFBL5Z0086
Cover (1)
TXFBL5Z0056
Cover is in the same bag
with Owner's Manual
Base (1)
TBL5ZX0328 (for 55")
TBL5ZX0381 (for 65")
from the TV.
from the cover.
from the Bracket.
from the Back of
9