Table of Contents
Advertisement
16
www.aeg.com
Problem
There is too much frost and
ice.
Water flows on the rear plate
of the refrigerator.
There is too much con‐
densed water on the rear
wall of the refrigerator.
Water flows on the floor.
Temperature cannot be set.
The temperature in the appli‐
ance is too low/too high.
Possible cause
The lamp is defective.
The door is not closed cor‐
rectly.
The gasket is deformed or
dirty.
Food products are not wrap‐
ped properly.
Temperature is set incorrect‐
ly.
Appliance is fully loaded and
is set to the lowest tempera‐
ture.
Temperature set in the appli‐
ance is too low and the am‐
bient temperature is too
high.
During the automatic de‐
frosting process, frost melts
on the rear plate.
Door was opened too fre‐
quently.
Door was not closed com‐
pletely.
Stored food was not wrap‐
ped.
The melting water outlet is
not connected to the evapo‐
rative tray above the com‐
pressor.
The "COOLMATIC function"
is switched on.
The temperature is not set
correctly.
Solution
Contact the nearest Author‐
ized Service Centre.
Refer to "Closing the door"
section.
Refer to "Closing the door"
section.
Wrap the food products bet‐
ter.
Refer to "Control Panel"
chapter.
Set a higher temperature.
Refer to "Control Panel"
chapter.
Set a higher temperature.
Refer to "Control Panel"
chapter.
This is correct.
Open the door only when
necessary.
Make sure the door is closed
completely.
Wrap food in suitable pack‐
aging before storing it in the
appliance.
Attach the melting water out‐
let to the evaporative tray.
Switch off "COOLMATIC
function" manually, or wait
until the function deactivates
automatically to set the tem‐
perature. Refer to "COOL‐
MATIC function" section.
Set a higher/lower tempera‐
ture.
Advertisement
Table of Contents
