Advertisement
Operating instructions
read the entire iMpOrtant SaFety inFOrMatiOn section at the beginning of this
manual including all text under subheadings therein before set up or use of this product.
tool Set up
tO preVent SeriOuS inJury FrOM acciDentaL OperatiOn:
Make sure that the trigger is in the off-position and remove its Battery
pack before performing any procedure in this section.
charging
1. Plug the Power Supply into a grounded,
120VAC, 60Hz receptacle.
2. Plug the Charger into charger port
on the back of tool handle.
note: The Battery's capacity will increase
somewhat during the first few charging cycles.
A fully discharged Battery will take about 3 to 5
hours to fully charge. Recharging the Battery for
more than 5 hours can damage the battery cells.
Workpiece and Work area Set up
1. Designate a work area that is clean and well lit.
The work area must not allow access by children
or pets to prevent distraction and injury.
General Operating instructions
1. Place the proper driver bit into the Chuck.
2. Push Rotation Button to the left side
of the tool for clockwise rotation.
3. Push Rotation Button to the right side
of the tool for reverse rotation.
4. Depress Trigger to operate tool.
5. To deactivate the Trigger, leave Rotation
Button in the center position.
Page 8
For technical questions, please call 1-888-866-5797.
3. While charging, the Charger may become
warm to the touch. This is normal, and
does not indicate a problem.
4. The red LED will light continuously when the
Battery is charged. Unplug the Charger and
disconnect it from the tool when finished.
note: If the tool will not be used for long periods
of time, charge battery every 3-6 months. Before
storage, charge battery to full or no less than
half a charge to prevent damage to battery.
2. Secure loose workpieces using a vise or clamps
(not included) to prevent movement while working.
3. There must not be objects, such as utility lines,
nearby that will present a hazard while working.
note: To activate LED Worklight, depress Trigger
while Rotation Button is in any position.
6. To switch between straight grip and pistol
grip, push Handle Lock forward and adjust
Handle to the desired position.
7. To activate flashlight, use Flashlight
Switch at bottom of tool.
8. To prevent accidents, turn off the tool
after use. Clean, then store the tool
indoors out of children's reach.
Item 64313
Advertisement
