LG DLGX3471 Series Owner's Manual page 38

38
troUBlEsHootInG
Before Calling For Service (cont.)
Problem
Steam does not • Water level error.
generate but
no error code is
shown
Garments still • Too many or too different types
wrinkled after of garments in dryer.
STEAM FRESH™
There are no • The function of this cycle is to
creases left on remove wrinkles from fabric.
garment after
STEAM FRESH™
Garments have • This is normal.
static after
REDUCE STATIC
Garments are • Correct drying options not
too damp or selected.
too dry after
REDUCE STATIC
Garments are • Number of garments or load
not uniformly size not properly selected at the
damp after beginning of the cycle.
EASY IRON
Water drips • This is normal.
from door
during Steam
Cycle
Steam is not • This is normal.
visible during
Steam Cycle
Drum does not • This is normal.
turn during
Steam Cycle
Cannot see • This is normal.
steam vapor at
the beginning
of cycle
Possible Causes
• Unplug dryer and call for service.
• Small loads of 1 to 5 items work best.
• Load fewer garments. Load similar-type garments.
• Use an iron to make creases.
• Depends on individual moisture level in skin.
• Select load weight manually before starting REDUCE
STATIC option.
• Select the correct number or garments or load size before
starting the cycle.
• Condensation will normally form on the inside of the
dryer door during steam operation. Some condensation
may drip out the bottom of the door.
• Steam vapor is difficult to see when the door is closed.
However, condensation will normally form on the inside of
the dryer door if the steam system is operating normally.
• The drum is turned off so that the steam vapor remains in
the drum. The drum will normally turn for about 2 seconds
once a minute.
• Steam is released at different stages of the cycle for each
option.
Solutions