Matrix Switch Corporation MSC-2HD0832S Product Manual page 56

Commands for installing tftp on different Linux distributions:
Ubuntu: sudo apt install tftp-hpa
•
Fedora: yum install tftp
•
Suse: smart install tftp
•
Using the tftp application on Linux:
1. Copy the firmware file to somewhere easily accessible from the Terminal application, for example the
Desktop.
2. Open a Terminal command line application (CTRL-ALT-T will do this on many desktop
environments).
3. Use 'cd' commands to change to the directory where the firmware file is located, for example (if the
firmware file is on your desktop) 'cd ~/Desktop' followed by the ENTER key.
4. Execute the tftp command with the IP address of the device (make sure to use the device's configured IP
if the update method being used utilizes the devices IP address):
tftp 192.168.2.59
5. Execute the following commands from within the tftp program, pressing ENTER after each line, except
the last one, to prepare the TFTP transfer:
binary
put MSC-Carina-Firmware-x.x.x.hex
6. Make sure to replace MSC-Carina-Firmware-x.x.x.hex with the correct version number of the file.
7. Pressing ENTER after the put command will initiate the TFTP transfer. Make sure to perform the
necessary actions to prepare the system for an update, prior to attempting the transfer.
8. The TFTP program will indicate if the transfer was successful or not.
9. If the transfer failed (timed out, etc), retry the put command or quit the application (type 'quit' and
ENTER) and start over from step 4.
Page 56 of 60
MSC-2HD0832S Product Manual
© 2013-2018 Matrix Switch Corporation www.matrixswitch corp.com