Mr. Heater MHVFBF10NG Operating Instructions And Owner's Manual page 7

Attaching Mounting Bracket to Wall
Use holes on each end of mounting bracket to attach
bracket to wall. These holes are 16 inches apart. Attach
mounting bracket to wall in one of two following ways.
1. Attach to wall studs
2. Attach to wall anchor
Attaching to Wall Stud:
This way is the best providing the strongest mounting in
wood frame houses.
Attaching to Wall Anchor:
This way allows you to attach mounting bracket to hollow
walls (wall areas between studs) or to solid walls (concrete
or masonry).
Decide which way best suits your needs. Either method will
provide a secure hold for the mounting bracket.
1. Tape mounting bracket to wall where heater will
be located. Make sure mounting bracket is level.
For wall stud mounting locate one end of the
mounting bracket over a wall stud.
WARNING: Maintain minimum clearances shown in fig-
ure 7. If you can, provide greater clearances from the floor
and joining wall.
2. Mark screw locations on wall (see figure 7).
3. Remove tape and mount bracket from wall.
See clearance
specs on Pg 3
16" (Lg)
12-9/64" (Sm)
Mark mounting hole locations
and drill holes where indicated.
Allow for minimum clearances
Figure 7
Attaching to Wall Stud:
For attaching mounting bracket to wall studs
1. Drill holes at marked locations using 9/64" drill bit.
2. Place mounting bracket onto wall. Line up holes on
each end of bracket with hole drilled in wall.
3. Insert mounting screws through bracket and into
wall studs.
4. Tighten screws until mounting bracket is firmly
fastened to wall studs.
Attaching to Wall using Anchor:
For attaching mounting bracket to hollow walls (wall areas
between studs) or solid walls (concrete or masonry)
Note: Wall anchors, mounting screws, and spacer are in
hardware package. The hardware package is provided
Unvented Natural Gas Fired Room Heater
with heater.
1.
2. Fold wall anchor as shown in figure 8 below.
3. Insert wall anchor (wings first) into hole. Tap
4. For thin walls (1/2" or less) insert red key into wall
5. Place mounting bracket onto wall. Line up holes on
6. Insert mounting screws through bracket and into
7.
Placing Heater on Mounting Bracket
1.
2. Place heater onto mounting bracket. Slide
18" Min.
Installing Bottom Mounting Screws
1.
Screw
hole
2. Mark screws locations on wall.
3. Remove heater from mounting bracket.
4. If installing bottom mounting screw into hollow
7
Installation Instructions and Owner's Manual
Drill holes at marked locations using 5/16" drill bit.
For solid walls (concrete or masonry), drill at least
1" deep.
Figure 8.
anchor flush to wall.
anchor.
each end of bracket with wall anchors.
wall anchors.
Tighten screws until mounting bracket is firmly
fastened to wall.
Locate two horizontal slots on back pane of heater
(see figure 9).
horizontal slots onto stand-out tabs on mounting
bracket.
Figure 9
Locate two bottom mounting holes. These holes
are near bottom on back panel of heater (see
figure 10).
Figure 10
or solid wall, install wall anchors. Follow steps 1
Horizontal Slots
Mounting Bracket
mounted to wall
Screw
hole