Closing The Door - Zanussi ZBF11421SV User Manual

Problem
There is too much frost and
ice.
The compressor does not start
immediately after pressing the
QuickFreeze, or after changing
the temperature.
Temperature cannot be set.
The temperature in the appli-
ance is too low/too high.
Door does not open easily.
If the advice does not lead to the
desired result, call the nearest
Authorized Service Centre.
Possible cause
The door is not closed correct-
ly or the gasket is deformed/
dirty.
The water drainage plug is not
correctly positioned.
Food products are not wrap-
ped properly.
Temperature is set incorrectly.
This is normal, no error has oc-
curred.
The QuickFreeze function is
switched on.
The temperature regulator is
not set correctly.
The door is not closed correct-
ly.
The food products' tempera-
ture is too high.
Many food products are stored
at the same time.
The thickness of the frost is
greater than 4-5 mm.
The door has been opened of-
ten.
The QuickFreeze function is
switched on.
There is no cold air circulation
in the appliance.
You attempted to re-open the
door immediately after closing.

CLOSING THE DOOR

1. Clean the door gaskets.
2. If necessary, adjust the door. Refer to assembly
instructions.
Solution
Refer to "Closing the door".
Position the water drainage
plug in the correct way.
Wrap the food products better.
Refer to "Operation" chapter.
The compressor starts after a
period of time.
Switch off QuickFreeze man-
ually, or wait until the function
resets automatically to set the
temperature. Refer to "Quick-
Freeze function"
Set a higher/lower tempera-
ture.
Refer to "Closing the door".
Let the food products temper-
ature decrease to room tem-
perature before storage.
Store less food products at the
same time.
Defrost the appliance.
Open the door only if necessa-
ry.
Refer to "QuickFreeze func-
tion".
Make sure that there is cold air
circulation in the appliance.
Wait a few seconds between
closing and re-opening of the
door.
9