Back Panel; Troubleshooting - Fenton TL LED Series Instruction Manual

UNPACKING INSTRUCTION
CAUTION! Immediately upon receiving the product, carefully unpack the carton, check the contents to ensure that all parts are
present, and have been received in good condition. Notify the shipper immediately and retain packing material for inspection if
any parts appear damage from shipping or the package itself shows signs of mishandling. Save the package and all packing
materials. In the event that the product must be returned to the factory, it is important that the product be returned in the original
factory box and packing.
BACKPANEL
1. Signal Line Input
6.3mm (¼") jack line inputs.
2. Speaker Output
NL2 speaker output connector.
3. LED Switch ON/OFF
With this switch you can turn the LED at front side of speaker on
or off.
4. Speaker Input
Put the wiring of speaker cable under these connector screws or
use banana connector.

TROUBLESHOOTING

One certain method of determining if a speaker is faulty is to substitute a speaker that is known to work correctly for
the suspected problem speaker. If the "normally correct speaker" is experiencing the same difficulties or problems
as the suspected problem speaker, use the information below to isolate the problem.
Constant noise, buzzing and/or humming
Possible cause
Faulty electronic
Poor low-frequency output
Possible cause
Improper polarity
Action
Any constant noise originates in the amplifier, mixer, signal processing, source device in
the signal devices, or line-level wiring. Check and correct system grounding as required.
Chain check for noisy sources or electronic components. Check wiring for shielding.
Action
When two speakers in close proximity to each other are connected out-of-polarity, they can
partially cancel each other out, especially at low frequencies. Check your cables to be sure
they are all identically wired and connected. Check the line signal cables to be sure they
are all correctly wired.
3