Table of Contents
Advertisement
Important: Some TV models have more than one USB port. You can connect your Live TV Pause
USB drive to any port, but make sure that nothing is connected to other USB ports while enabling
Live TV Pause. Reconnect other USB devices after you have finished enabling Live TV Pause.
4. Enable Live TV Pause, as explained in the following topic.
Enabling Live TV Pause
You can start setting up Live TV Pause in any of the following ways:
•
Go to Settings > TV inputs > Antenna TV > Live TV Pause, and then select Enable.
•
After completing a channel scan, select Set up Live TV Pause from the available options.
•
Press Play/Pause on the Roku remote while watching a digital Antenna TV channel.
•
Highlight the Antenna TV tile on the Home screen, press Þ on the remote, and then select
Enable Live TV Pause.
After starting setup of Live TV Pause in any of these ways, the TV prompts you through the steps needed
to enable this feature. Setup takes only a few moments.
Note: Use of a USB hub is not supported.
Using Live TV Pause
If you have used the Roku remote to watch streaming channels, using Live TV Pause should be very
familiar to you.
•
While watching a digital Antenna TV channel, press PLAY/PAUSE to pause or play the content.
After the TV program has been paused for 90 minutes, the TV resumes playing.
•
After watching a channel for a while, press REWIND to jump back up to the point where you
first started watching the channel, up to 90 minutes.
•
After pausing or rewinding, press FAST FORWARD to jump ahead up to the point where you
are once again watching the live TV program.
55
Advertisement
Table of Contents
