Table of Contents
Advertisement
Audio Settings
Each DVD disc has a variety of audio output options.
Set the recorder's Audio Output according to the type
of audio system you use.
Dolby Digital / DTS / MPEG
[Bitstream]: Select "Bitstream" if you connect the
recorder's DIGITAL AUDIO OUTPUT jack to an
amplifier or other equipment with a Dolby Digital,
DTS or MPEG decoder.
[PCM] (for Dolby Digital / MPEG): Select when
connected to a two-channel digital stereo amplifier.
DVDs encoded in Dolby Digital or MPEG will be
automatically downmixed to two-channel PCM
audio.
[Off] (for DTS): If you select "Off", the DTS signal is
not output through the DIGITAL AUDIO OUTPUT
jack.
Sampling Frequency
If your receiver or amplifier is NOT capable of
handling 96 kHz signals, select [48 kHz]. When this
choice is made, this unit will automatically convert any
96 kHz signals to 48 kHz so your system can decode
them.
If your receiver or amplifier is capable of handling
96 kHz signals, select [96 kHz]. When this choice is
made, this unit will pass each type of signal through
without any further processing.
DRC (Dynamic Range Control)
With the DVD format, you can hear a program's
soundtrack in the most accurate and realistic
presentation possible, thanks to digital audio
technology. However, you may wish to compress the
dynamic range of the audio output (the difference
between the loudest sounds and the quietest ones).
Then, you may listen to a movie at a lower volume
without losing clarity of sound. Set DRC to [ON] for
this effect.
Vocal
Set Vocal to [ON] only when a multi-channel karaoke
DVD is playing. The karaoke channels on the disc will
mix into normal stereo sound.
22
Lock (Parental Control) Settings
Lock System
Allows you to set up specific programs and ratings
through blocking schemes. Also allows you to activate
or disable all of the lock schemes previously set up. A
password is required to gain access to the lock menu
options. When the Lock System is set to [OFF], the
DTV Rating is not effective.
1. Select [Lock System] option then press B.
2. To access the Lock System, DVD Rating, DTV
Rating, Set Password and Area Code features,
you must input the 4-digit password you created.
If you have not yet entered a password you are
prompted to do so.
Input a 4-digit code. Enter it again to verify. If you
make a mistake, press CLEAR.
3. Select [ON] or [OFF] using the v / V buttons.
4. Press ENTER to confirm your setting.
DVD Rating
Blocks playback of rated DVDs based on their
content. Not all discs are rated.
1. Select [DVD Rating] option then press B.
2. Follow step 2 as shown "Lock System".
3. Select a rating using the v / V buttons.
[1] - [8]: Rating one (1) has the most restrictions
and rating eight (8) is the least restrictive.
[No Limit]: If you select [No Limit], parental control
is not active and the disc plays in full.
4. Press ENTER to confirm your rating selection.
Note:
If you set a rating for the recorder, all disc scenes with
the same rating or lower are played. Higher rated
scenes are not played unless an alternate scene is
available on the disc. The alternative must have the
same rating or a lower one. If no suitable alternative is
found, playback stops. You must enter the 4-digit
password or change the rating level in order to play
the disc.
Advertisement
Table of Contents
