Makita GBU01 Instruction Manual page 10

Switch action
WARNING:
Before installing the battery car-
tridge into the machine, always check to see that
the switch trigger actuates properly and returns
to the "OFF" position when released.
To start the machine, simply pull the switch trigger. The
speed increases by increasing pressure on the switch
trigger. Release the switch trigger to stop.
► 1. Switch trigger
You can use the machine in the Boost mode. In the
Boost mode, the air volume becomes larger than in the
normal mode. To use the machine in the Boost mode,
pull the switch trigger until the switch trigger stops in the
halfway position, and then pull the switch trigger fully.
► 1. Switch trigger
1
1
10 ENGLISH
NOTE: Depending on the usage conditions or battery
conditions, use of the Boost mode is restricted to
protect the machine. If the main power lamp of the
machine blinks in green when you pull the switch
trigger fully or while you are using the machine in the
Boost mode, the Boost mode is not available.
NOTE: The Boost mode is not available by turning
the control lever.
Cruise control function
The cruise control function allows the operator to main-
tain a constant speed without pulling the trigger. To
increase the speed, turn the control lever forward. To
decrease the speed, turn the control lever backward.
► 1. Control lever
Accidental re-start preventive
function
Even if you install the battery cartridge while pulling the
switch trigger, the machine does not start. To start the
machine, first release the switch trigger and return the
control lever fully, and then pull the switch trigger.
1