Table of Contents
Advertisement
Set digital output
Select a suitable setting if you have connected
an audio/video device to the COAXIAL
(DIGITAL AUDIO) socket on the recorder.
1
Press 设定.
2
Select [ Audio ] > [ Digital Output ], then
press OK.
3
Select an option and press OK.
[ PCM ]
Select this if the connected device cannot
decode multi-channel audio. The system
will convert the Dolby Digital and MPEG-2
multi-channel signals to PCM (Pulse Code
Modulation).
[ ALL ]
Select this if the connected device
supports multi-channel audio format. The
audio output will be played according to
the audio stream on the disc.
4
To exit, press 设定.
•
To cancel, press 返回.
Set HDMI audio
See the chapter "Adjust Settings – Adjust
HDMI video and audio".
1_dvdr3600_93_UM_En_28951.indd 51
1_dvdr3600_93_UM_En_28951.indd 51
Enable night mode
Night mode optimises playback of sound at low
volumes
1
Press 设定.
2
Select [ Audio ] > [ Night Mode ], then
press OK.
3
Select an option and press OK.
[ On ]
Enable night mode. High volume output is
softened and low volume output is
increased to an audible level.
[ Off ]
Disable night mode. Enjoy surround sound
with its full dynamic range.
4
To exit, press 设定.
•
To cancel, press 返回.
EN
51
2008-02-18 9:58:14 AM
2008-02-18 9:58:14 AM
Advertisement
Table of Contents
