Table of Contents
Advertisement
Connections
ips
Depending on your TV and other equipment you wish
to connect, there are various ways you could connect
the recorder. Use only one of the connections
described below.
Please refer to the manuals of your TV, VCR, Stereo
System or other devices as necessary to make the
best connections.
Caution
– Make sure the Recorder is connected directly to the
TV. Tune the TV to the correct video input channel.
– Do not connect the Recorder's AUDIO OUTPUT jack to
the phono in jack (record deck) of your audio system.
– Do not connect your Recorder via your VCR.
The DVD image could be distorted by the copy pro-
tection system.
Connecting to the Aerial
Remove the aerial cable plug from your TV set and
insert it into the aerial socket at the back of the
recorder. Plug one end of the aerial cable into the TV
socket on the recorder and the other end into the aerial
input socket on your TV set.
RF coaxial connection
Connect the ANTENNA OUT jack on the Recorder to
the aerial input jack on the TV using the 75-ohm Coaxial
Cable supplied (R). The ANTENNA OUT jack passes
the signal through from the ANTENNA IN jack.
Aerial
ANTENNA
INPUT
R
Connections to Your TV
Make one of the following connections, depending on
the capabilities of your existing equipment.
SCART connection
Connect the AV1 scart jack on the Recorder to the cor-
responding jacks on the TV using the scart cable (T).
S-Video connection
Connect the S-VIDEO OUTPUT jack on the Recorder to
the S-Video in jack on the TV using the S-Video cable
(S).
Rear of TV
SCART INPUT
VIDEO
AUDIO INPUT
INPUT
L
R
Rear of Recorder
Component Video connection
Connect the COMPONENT OUTPUT jacks on the
Recorder to the corresponding input jacks on the TV
using an Y P
P
cable (C).
B
R
Progressive Scan connection
If your television is a high-definition or "digital ready" tel-
evision, you may take advantage of the recorder's pro-
gressive scan output for the highest video resolution
possible. If your TV does not accept the Progressive
Scan format, the picture will appear scrambled if you try
Progressive Scan on the recorder.
Connect the COMPONENT OUTPUT jacks on the
Recorder to the corresponding input jacks on the TV
using an Y P
P
cable (C).
B
R
otes
– Set the resolution to 576p by pressing P/SCAN for
progressive signal, see page 10.
– The resolution will not be set to "576p" when the
video output switch is at RGB position.
– Progressive scan does not work with the analog video
connections or S-VIDEO connection.
– If you are using the COMPONENT OUTPUT jacks,
but are connecting the unit to a standard (analog)
television, set the resolution to "576i".
Audio (Left/Right) Connection
Connect the left and right AUDIO OUTPUT jacks of the
Recorder to the audio left and right IN jacks on the TV
using the audio cables (A). Do not connect the
Recorder's AUDIO OUTPUT jack to the phono in jack
(record deck) of your audio system.
Rear of TV
S-VIDEO
VIDEO
COMPONENT INPUT
INPUT
INPUT
Y
Pb
C
S
SCART INPUT
AUDIO INPUT
Pr
L
R
A
T
Rear of Recorder
13
Advertisement
Table of Contents
