Troubleshooting Guide - Bosch SPE68U55UC Operating Instructions Manual

Troubleshooting Guide

Dishwashers may occasionally exhibit problems that are unrelated to a malfunction of the dishwasher itself. The
following information may help you with a dishwasher problem without involving a repair professional.
Problem
Cycle does 1. Door is opened longer than 4 seconds after a
not resume cycle has started.
after door is
opened and
closed
during cycle.
1. Door may not be properly latched.
2. Unit may not be turned on.
3. Unit not reset or previous cycle not com-
pleted.
Dishwasher
4. Delay start engaged.
does not
5. Interruption of electrical power supply to
start.
dishwasher by tripped circuit breaker or
blown fuse.
6. The door may have been closed without
first selecting a cycle.
7. Water supply may not be turned on.
Display does 1. A fuse may have been blown or circuit
not illumi- breaker tripped.
nate or con- 2. Door not closed or latched.
sole lights
are not on.
Dishwasher 1. Incoming water is not warm enough.
seems to run 2. Cycle time can vary due to soil and water
a long time. conditions.
3. Rinse aid dispenser is empty or rinse-aid
setting has been set to r:00.
4. Dishwasher connected to cold water sup-
ply.
Note: Refer to "Wash Cycle Information" sec-
tion in this manual for typical cycle lengths.
Dishes are 1. Spray arm movement obstructed.
not getting 2. Spray arm nozzles clogged.
clean 3. Improper use of detergents.
enough. 4. Filters could be clogged.
5. Dishes are nested or loaded too close
together.
6. Selected wash cycle is not suitable for food
soil conditions.
Cause Action
1. Press [START / RESUME] button and close the
door within 4 seconds to resume cycle.
1. Shut the door completely.
2. Press the main power switch to turn unit on.
3. To reset, refer to "Operating the Dish-
washer" in this manual.
4. To reset, refer to "Delay Start" section in this
manual.
5. Reset circuit breaker or replace blown fuse.
6. Select a cycle and press START/RESUME.
7. Turn on water supply.
1. Check the fuse or circuit breaker box and
replace the fuse or reset the breaker if neces-
sary.
2. Ensure door is properly latched and com-
pletely closed.
1. Before starting a cycle, run hot water faucet
at the sink closest to the dishwasher.
2. Sensors in the dishwasher automatically
increase the cycle time to ensure a good wash
when heavy soil is detected.
3. Add rinse aid or change rinse-aid setting.
4. Verify dishwasher is connected to hot water
supply plumbing.
1. Ensure that spray arm movement is not
blocked by hand rotating spray arms before
starting cycle.
2. Remove the spray arms and clean according
to the "Care and Maintenance" section of the
manual.
3. Increase or decrease detergent depending
on the water hardness (refer to Table 1).
4. Clean the filters according to the "Care and
Maintenance" section of the manual.
5. Rearrange load such that water spray can
reach all items in the dishwasher - see "Loading
the Dishwasher" section of the manual.
6. Refer to "Wash Cycle Information" section of
the manual.
19