GE GBF630SGLBB Installation Instructions Manual

GE GBF630SGLBB Installation Instructions Manual

Hide thumbs Also See for GBF630SGLBB:

Advertisement

Available languages

Available languages

Quick Links

Installation
Instructions
La section française commence après la section anglaise
If you have questions, call 1-800-561-3344 or visit our website at: www.GEAppliances.ca
BEFORE YOU BEGIN
Read these instructions completely and
carefully.
IMPORTANT
governing codes and ordinances.
• Note to Installer – Be sure to leave these instructions
for the consumer's and local inspector's use.
• Note to Consumer – Keep these instructions with your
Owner's Manual for future reference.
• Skill Level – Installation of this dishwasher requires
basic mechanical and electrical skills. Proper
installation is the responsibility of the installer.
Product failure due to improper installation is not
covered under the GE Appliance Warranty.
• Completion Time – 1 to 3 Hours. New installations
require more time than replacement installations.
Observe all
Dishwasher
IMPORTANT
MUST be installed to allow for future removal from
the enclosure if service is required.
If you received a damaged dishwasher, you should
immediately contact your dealer or builder.
FOR YOUR SAFETY
Read and observe all CAUTIONS and WARNINGS
shown throughout these instructions. While performing
installations described in this booklet, gloves, safety
glasses or goggles should be worn.
WARNING
To reduce the risk of electrical shock, fire,
or injury to persons, the installer must
ensure that the dishwasher is completely
enclosed at the time of installation.
READ CAREFULLY.
KEEP THESE INSTRUCTIONS.
If you have an installation problem, contact your
dealer or installer. You are responsible for providing
adequate electrical, exhausting and other connecting
facilities.
PUB NO.29-5905 7/23/13 MC
The dishwasher

Advertisement

Table of Contents
loading

Summary of Contents for GE GBF630SGLBB

  • Page 1 To reduce the risk of electrical shock, fire, Product failure due to improper installation is not or injury to persons, the installer must covered under the GE Appliance Warranty. ensure that the dishwasher is completely • Completion Time – 1 to 3 Hours. New installations enclosed at the time of installation.
  • Page 2: Parts Supplied

    Installation Preparation PARTS SUPPLIED: Two #8 Phillips fl at head wood screws, 5/8" long to secure dishwasher to underside of countertop (in literature package). Two Phillips head, color matched toekick screws 2 Side 2 Top (in literature package). 2 Wood Screws 2 Color Matched Mounting Clips Mounting Clips...
  • Page 3 Installation Preparation • The dishwasher must be installed so that drain hose is no more than 10 feet in length for proper drainage. • The dishwasher must be fully enclosed on the top, sides and back, and must not support any part of the enclosure.
  • Page 4: Prepare Electrical Wiring

    Installation Preparation PREPARE ELECTRICAL WIRING WARNING FOR PERSONAL SAFETY: Remove house fuse or open circuit breaker before beginning installation. Do not use an 1-1/2" Dia. extension cord or adapter plug with this Hole (Max.) appliance. 3" Electrical Requirements from • This appliance must be supplied with 120V, 60 Hz., and Cabinet connected to an individual properly grounded branch 24"...
  • Page 5: Before You Begin

    Installation Instructions BEFORE YOU BEGIN PREPARE HOT WATER LINE • The line may enter from either side, rear or fl oor Locate and set aside the package containing within the shaded area shown in Figure F. 2 Phillips head countertop mounting screws •...
  • Page 6 • Move the dishwasher close to the installation loca- power cord kit WX09X70910 available for purchase from tion and lay it on its back. an authorized GE Appliances dealer. The power cord and connections must comply with the National Electrical Code, Section 422 and/or local codes and ordinances.
  • Page 7: Step 6 Position Water Line And House Wiring

    Installation Instructions STEP 6 POSITION WATER LINE STEP 8 SLIDE DISHWASHER AND HOUSE WIRING PARTIALLY INTO CABINET • Position water supply line and house wiring on the DO NOT PUSH AGAINST FRONT PANEL WITH KNEES. fl oor of the opening to avoid interference with base DAMAGE WILL OCCUR.
  • Page 8: Step 9 Position Dishwasher Under Countertop

    Installation Instructions STEP 9 POSITION DISHWASHER UNDER COUNTERTOP Reposition Dishwasher • Check to be sure that wires are secure under the by Grasping Both dishwasher and not pinched or in contact with door Sides With Hands springs or other dishwasher components. TIP: Check tub insulation blanket, if equipped.
  • Page 9: Step 11 Secure Dishwasher To Cabinet

    Installation Instructions Open the door remove the tub cap on both sides of STEP 11 SECURE DISHWASHER the tub. Install screw through the dishwasher side hole TO CABINET to the wall of cabinet. Reinstall tub cap. Method 1: To install using Top Mount Cabinet Clips. Depending on the depth of cabinet,the Top Mount Clip have a break off point that can be removed if necessary.
  • Page 10: Step 13 Connect Drain Line

    Installation Instructions STEP 13 CONNECT DRAIN LINE DRAIN LINE INSTALLATION • Connect drain line to air gap, waste tee or disposer FOLLOW ALL LOCAL CODES AND ORDINANCES. using either previously determined method. The drain hose molded end will fi t 5/8", 3/4" or 1" Method 1 –...
  • Page 11: Step 14 Connect Power Supply

    Installation Instructions STEP 14 CONNECT POWER STEP 15 PRE-TEST CHECKLIST SUPPLY Review this list after installing your dishwasher to avoid charges for a service call that is not covered Skip this step if equipped with power cord. by your warranty. Verify that power is turned off at the source.
  • Page 12 Installation Instructions STEP 16 DISHWASHER WET TEST STEP 17 REPLACE TOEKICK Turn on power supply (or plug power cord into outlet, if equipped). Turn on your dishwasher (please refer to the Owner's Manual for instructions). Close door, select RINSE ONLY cycle and press START/CANCEL.
  • Page 13: Pour Votre Sécurité

    L’installateur est responsable de la qualité de l’installation. Pendant l’installation décrite dans ce manuel, il est La garantie des électroménagers GE ne couvre pas les recommandé de porter des gants et des lunettes de sécurité. défaillances du produit provoquées par une mauvaise AVERTISSEMENT installation.
  • Page 14: Pièces Fournies

    Préparatifs d’installation PIÈCES FOURNIES : Deux vis à bois à tête plate Phillips n° 8, 5/8 po de longueur pour fi xer le lave-vaisselle à la face inférieure du plan de travail (dans l’enveloppe de la documentation). Deux vis Phillips assorties à la couleur de la plinthe. (dans l’enveloppe de la documentation).
  • Page 15 Préparatifs d’installation • Le lave-vaisselle doit être installé de façon que la longueur du tuyau fl exible d’évacuation ne dépasse pas 3,04 m (10 pieds) afi n d’obtenir une bonne évacuation. • Le lave-vaisselle doit être complètement fermé sur le dessus, les côtés et à...
  • Page 16 Préparatifs d’installation PRÉPARATION DU CÂBLAGE ÉLECTRIQUE AVERTISSEMENT POUR VOTRE SÉCURITÉ : Enlevez le fusible ou déclenchez le disjoncteur au panneau de distribution électrique avant d’entreprendre Trou de 3,8 cm (1-½ po) de diam. (max.) l’installation. N’utilisez pas de rallonge électrique ni de fi che d’adaptation avec cet appareil.
  • Page 17: Préparation Du Tuyau D'eau Chaude

    Instructions d’installation PRÉPARATION DU TUYAU D’EAU AVANT DE COMMENCER CHAUDE Repérez et mettez de côté l’enveloppe contenant les deux vis Phillips pour fi xer le lave-vaisselle sous • Le tuyau peut entrer d’un côté ou de l’autre, de l’arrière ou le plan de travail et les deux vis supplémentaires du plancher, dans la zone hachurée montrée à...
  • Page 18 Utilisez l’ensemble de cordon d’alimentation WX09X70910 en vente faites-le basculer sur le dos. chez votre détaillant d’appareils GE autorisé. Le cordon d’alimentation et les connexions doivent être conformes aux normes du code na- tional d’électricité et/ou aux codes et règlements locaux en vigueur.
  • Page 19 Instructions d’installation MISE EN PLACE DU GLISSEZ LE LAVE-VAIS- ÉTAPE 8 ÉTAPE 6 TUYAU ET DU CÂBLAGE SELLE PARTIELLEMENT DANS DE LA MAISON L’OUVERTURE DE L’ARMOIRE • Placez le tuyau d’alimentation en eau et le câblage NE POUSSEZ PAS LE PANNEAU AVANT AVEC LES GENOUX, CELA électrique de la maison sur le plancher de l’ouverture afi...
  • Page 20 Instructions d’installation MISE EN PLACE DU LAVE-VAISSELLE ÉTAPE 9 SOUS LE PLAN DE TRAVAIL Replacez le lave-vaisselle en tenant les deux côtés • Assurez-vous que le câblage électrique est bien en place avec les mains. sous le lave-vaisselle et qu’il n’est pas pincé ou en contact avec les ressorts de la porte ou tout autre élément du lave- vaisselle.
  • Page 21 Instructions d’installation FIXATION DU LAVE- ÉTAPE 11 ÉTAPE 12 BRANCHEMENT DE VAISSELLE À L’ARMOIRE L’ALIMENTATION EN EAU Branchez le tuyau d’alimentation en eau au coude de 90°. Le lave-vaisselle doit être fi xé au plan de travail. • Glissez l’écrou à compression, puis la bague d’extrémité •...
  • Page 22: Installation Du Tuyau D'évacuation

    Instructions d’installation BRANCHEMENT DU ÉTAPE 13 INSTALLATION DU TUYAU TUYAU D’ÉVACUATION D’ÉVACUATION • Branchez le tuyau d’évacuation au brise-vide, au raccord OBSERVEZ TOUS LES CODES ET RÈGLEMENTS en T ou au broyeur en vous servant de l’une des méthodes EN VIGUEUR. décrites précédemment.
  • Page 23: Étape 14 Branchement De L'alimentation Électrique

    Instructions d’installation BRANCHEMENT DE LISTE DE VÉRIFICATION ÉTAPE 15 ÉTAPE 14 L’ALIMENTATION AVANT L'ESSAI ÉLECTRIQUE Examinez cette liste après l’installation du lave-vaisselle pour éviter des frais de dépannage qui ne sont pas couverts par la Passez à l'étape suivante si le lave-vaisselle est muni d’un garantie.
  • Page 24 Instructions d’installation REPOSE DE LA PLINTHE ESSAI DU LAVE-VAISSELLE ÉTAPE 17 ÉTAPE 16 AVEC DE L’EAU Mettez le circuit sous tension (ou branchez le cordon d’alimentation dans la prise de courant, le cas échéant). Mettez le lave-vaisselle sous tension (référez-vous au manuel d'utilisateur).

This manual is also suitable for:

Gbf630smles

Table of Contents