EXTERNAL EQUIPMENT SETUP
To avoid damaging any equipment, never plug in any power cord until you have finished connecting all equipment.
■
This section on EXTERNAL EQUIPMENT SETUP mainly uses diagrams for the 50/60PS70 ** , 50/60PS80 ** models.
■
Image shown may differ from your TV.
■
HD RECEIVER SETUP
This TV can receive Digital RF/Cable signals without an external digital set-top box. However, if you do receive
■
Digital signals from a digital set-top box or other digital external device, refer to the diagram as shown below.
Connecting with a Component cable
Connect the video outputs ( Y, P
1
top box to the C C O O M M P P O O N N E E N N T T I I N N V V I I D D E E O O jacks on the
TV.
2
Connect the audio output of the digital set-top box to
the C C O O M M P P O O N N E E N N T T I I N N A A U U D D I I O O jacks on the TV.
3
Turn on the digital set-top box.
( Refer to the owner's manual for the digital set-top box. )
Select C C o o m m p p o o n n e e n n t t input source using the I I N N P P U U T T
4
button on the remote control.
HDMI Audio Supported format : Dolby Digital, PCM
G G
DTS Audio format is not supported.
Signal
480i/576i
480p/576p
720p/1080i
1080p
(50 Hz / 60 Hz only)
) of the digital set
, P
B
R
Component
O
O
O
O
(24 Hz / 30 Hz / 50 Hz / 60 Hz)
HDMI
X
O
O
O
1
2
37