Whirlpool WDF330PAHT User Instructions page 7

NOTE: For most water conditions, the factory setting will give
good results.
Check water hardness level to ensure there are no rings or
■
spots on your dishware before adding rinse aid or adjusting
the factory setting.
If you have hard water or notice rings or spots, try
■
a higher setting.
Turn the arrow adjuster inside the
dispenser by either using your fingers or
inserting a flat-blade screwdriver into the
center of the arrow and turning.
Select a Cycle (cycles vary by model)
See "Cycle and Option Descriptions" charts in the following section.
Heavier cycles and options affect cycle length.
Select Options (options vary by model)
See "Cycle and Option Descriptions" charts in the following section.
You can customize your cycles by pressing the options desired.
STEP 3
Start or Resume a Cycle
Run hot water at the sink nearest to your dishwasher until the
■
water is hot. Turn off water.
For best dishwashing results, water should be 120ºF (49ºC)
■
as it enters the dishwasher.
Push door firmly closed. The door latches automatically.
■
Select the wash cycle, options and press START/RESUME or
press START/RESUME to repeat the same cycle and options
as in the previous wash cycle.
For models with controls on top of the door, select wash
cycle, option, and press START/RESUME within 4 seconds
of closing the door.
You can add an item anytime at the beginning of the cycle.
■
Open the door slowly and add the item. Close the door firmly.
Press START/RESUME.
STEP 4
7