Troubleshooting; Specifications - Kenwood C-BX3-B Instruction Manual

Table of Contents

Advertisement

Troubleshooting

If you have a problem with this System, check this list for a possible
solution before calling for service.
Power
Power does not come on.
=
The power cord is not inserted securely. Plug it in securely.
The unit suddenly turns off.
=
Auto power save function is on. Refer to "Activating/deactivating
APS (Auto Power Save)" in "Basic operation."
Remote control
The remote control does not work.
=
Pull out the insulation sheet.
=
Sunlight is shining directly on the remote sensor. Hide the remote
sensor from direct sunlight.
=
The path between the remote control and the remote sensor on
the front panel is blocked.
=
Point the remote control at the remote sensor on the front panel.
=
Signals cannot reach the remote sensor. Move closer to the unit.
=
The battery is exhausted. Replace the battery.
External components
No sound can be heard when DIGITAL 1 or DIGITAL 2 is
selected as a source.
=
Check the output setting of the connected digital components.
Set the output setting to PCM signal. (Refer to "Specifications" for
more information.)
iPod
iPod cannot be connected firmly.
=
Check to see whether the connector between iPod and the unit is
not damaged, and connect it.
iPod does not provide sound.
=
iPod is not properly connected. Remove iPod from the unit, and
then connect it again.
iPod cannot be charged.
=
iPod is not properly connected. Remove iPod from the unit, and
then connect it again. After connecting iPod, turn on the power
again.

Specifications

Output Power : 30 W + 30 W RMS (1 kHz, 10% T.H.D., 4 Ω)
Audio section
Input Terminals : ANALOG IN : 1 V/50 kΩ
Digital Input Terminals* :
DIGITAL IN 1 (OPTICAL) : –21 dBm to –15 dBm (660 nm ±30 nm)
DIGITAL IN 2 (COAXIAL) : 0.5 Vp-p/75 Ω
Output Terminals : SUBWOOFER PRE-OUT : 400 mV/10 kΩ
Speaker section
Type : Bass-Reflex Type
Speaker : 80 mm cone × 2
Impedance : 4 Ω
Frequency Range : 50 Hz to 25 kHz
Sound Pressure Level : 84 dB/W•m
General
Power Source (DC IN) : DC 19 V
AC Adaptor (AC-190337A) :
Input : AC 110 – 240 V
, 50 Hz/60 Hz, 1.5 A – 0.9 A
Output : DC 19 V
3.37 A
Power Consumption : 0.5 W or less (in Standby mode)
Dimensions (W × H × D) :
Whole system (assembled) : 500 mm × 550 mm × 400 mm
Main unit (with top glass) : 500 mm × 110 mm × 300 mm
Weight (nett) :
Whole system (assembled) : 13.2 kg
Main unit (with top glass) : 8.0 kg
Maximum loadable weight : 20.0 kg
iPod
Output Power : DC 5 V
1 A
Video Out (VIDEO OUT) : Composite
*
Corresponding to Linear PCM only (with sampling frequency — 32 kHz,
44.1 kHz, 48 kHz)
When an audio signal other than Linear PCM comes in, NONPCM
appears on the display.
Design and specifications are subject to change without notice.
3.37 A
11
English

Advertisement

Table of Contents
loading

Table of Contents