Using the SONG RECORDER
Button
Each press of the SONG RECORDER button cycles
through the recording options in the sequence shown
below.
Lit
Flashing
Playback
Standby
Standby
Recording to a Specific Song Track
After recording to either of the tracks of a song, you can
record to the other track while listening to playback
what you recorded in the first track.
1.
Press the SONG RECORDER button twice
so its lamp is flashing.
• At this time the L lamp will flash to indicate that the
Digital Piano is standing by for recording to Track 1.
2.
While holding down the FUNCTION button,
press the SONG RECORDER (L/R) button to
select the track you want to record.
• Make sure that the indicator lamp for the record track
is flashing.
Track 1: L lamp
Track 2: R lamp
Example:
Track 1 selected
Off
Record
Normal
3.
Select the tone and effects (Track 1 only) you
want to use in your recording.
• Tone (page EN-7)
• Effects (page EN-10)
NOTE
• If you want the metronome to sound while you are
recording, configure the beat and tempo settings,
and then press the METRONOME button. See
"Using the Metronome" on page EN-12 for more
information.
4.
Start playing something on the keyboard.
• Recording will start automatically.
5.
To stop recording, press the START/STOP
a button.
• This will cause the SONG RECORDER button lamp
and the lamp of the track you recorded to change
from flashing to lit.
• To play back the track you just recorded, press the
START/STOP a button.
6.
After you are finished recording or playing
back, press the SONG RECORDER button
so its lamp goes out.
Recording and Playback
EN-21