Turning Power On Or Off; Returning The Digital Piano To Its Factory Default Settings - Casio Celviano AP-270 BK User Manual

Power Outlet
After you finish assembling the stand, turn on the
Digital Piano. For details, see "Getting Ready" on page
EN-31.

Turning Power On or Off

1.
Press the P (POWER) button to turn on
Digital Piano power.
• The power lamp lights and the Digital Piano powers
up. The power up operation takes about 5 seconds.
2.
To turn off the Digital Piano, hold down the
P (POWER) button until the power lamp
goes out.
NOTE
• Pressing the P (POWER) button to turn off power
actually puts the Digital Piano into a standby state.
Minute amounts of current continue to flow within
the Digital Piano in the standby state. If you do not
plan to use the Digital Piano for a long time or if
there is a lightning storm in your area, be sure to
unplug the AC adaptor from the power outlet.
Auto Power Off
This Digital Piano is designed to turn off automatically
to avoid wasting power after no operation is
performed for a preset amount of time. The Auto
Power Off trigger time is about four hours.
• You also can use the procedure below to temporarily
suspend Auto Power Off.
■ To disable Auto Power Off
1.
While the Digital Piano is turned on, press the
P (POWER) button to turn it off.
2.
While holding down the FUNCTION button,
press the P (POWER) button to turn on the
Digital Piano.
• Auto Power Off will be disabled at this time.
NOTE
• Turning off the Digital Piano after performing the
above steps will re-enable Auto Power Off.
Returning the Digital Piano to
Its Factory Default Settings
Perform the following procedure when you want to
return the Digital Piano's stored data and settings to
their initial factory defaults.
1.
Turn off the Digital Piano.
2.
Holding down the FUNCTION, MIDI REC and
GRAND PIANO 2 buttons, press the
P (POWER) button.
3.
Hold down the FUNCTION, MIDI REC and
GRAND PIANO 2 buttons until the GRAND
PIANO 2 lamp, and then the GRAND PIANO 1
lamp, and then the R lamp start to flash.
• After some time, the flashing will stop.
4.
Release the FUNCTION, MIDI REC and
GRAND PIANO 2 buttons.
• The Digital Piano will initialize its internal system.
You will be able to use the Digital Piano in a short
while.
NOTE
• See "Turning Power On or Off" (page EN-5) for
information about turning power on and off.
EN-5