Table of Contents
Advertisement
en Troubleshooting
Errors
The spin cycle runs several
times.
The programme duration
changes during the wash
cycle.
No water is visible in the
drum.
Drum jerks after the pro-
gramme starts.
Residual water is present in
the compartment
Vibrations and movement of
the appliance whilst spinning.
Drum does not turn, water
does not flow in.
56
Cause
The unbalanced load detec-
tion system eliminates an im-
balance by repeatedly redis-
tributing the laundry.
The programme operation is
optimised electronically. This
may change the programme
duration.
The unbalanced load detec-
tion system eliminates an im-
balance by repeatedly redis-
tributing the laundry.
Foam detection system
switches on a rinse cycle if
foam build-up is too high.
Water is below the visible
area.
This is caused by an internal
motor test.
Insert in compartment
.
blocked.
Appliance is not correctly
aligned.
The appliance feet are not
fixed.
Transit bolts have not been re-
moved.
Load detection is active.
Troubleshooting
Not a fault – no action required.
▶
Note: When loading, where possible,
place large and small items of laundry to-
gether in the drum. Different sized items
of laundry distribute themselves better
during the spin cycle.
Not a fault – no action required.
▶
Not a fault – no action required.
▶
Note: When loading, where possible,
place large and small items of laundry to-
gether in the drum. Different sized items
of laundry distribute themselves better
during the spin cycle.
Not a fault – no action required.
▶
Not a fault – no action required.
▶
Not a fault – no action required.
▶
→ "Cleaning the detergent drawer",
is
▶
Page 46
→ "Aligning the appliance", Page 16
▶
Secure the appliance feet.
▶
→ "Aligning the appliance", Page 16
→ "Removing the transit bolts",
▶
Page 14
Not a fault – no action required.
▶
Note: The load detection can take up to
two minutes.
Advertisement
Table of Contents
