LG DLE8377CM Owner's Manual page 14

Part 4 ACCESSORIES INSTALLATION
Pedestal Installation Instructions
The pedestal accessory includes:
• Drawer divider (1)
• Screws (18) †
† Dryer installation only uses 8 screws
†† For dryer only
Tools Needed for Installation:
• Phillips-head screwdriver
• Wrench (supplied)
To ensure safe and secure installation, please
thoroughly follow the instructions below.
1
To set the dryer to the same height as the
washer, fully retract the leveling feet of the
dryer by turning them counterclockwise, then
turn them clockwise 1-1/2 turns.
NOTE: The appliance and pedestal assembly
must be placed on a solid, sturdy, level floor
for proper operation.
Retract fully
2
Insert the T-clip of the 4 retainers into the dryer
base as shown. Press up on the back of the
1
clip and pull outward to lock into place.
Retainer
1 4
• Wrench (1)
• Retainers (4) ††
Then loosen
1-1/2 turns
T-clip
3
Place the dryer on the
pedestal. Make sure
the front and back
feet are in the correct
positions. The dryer
feet will fit into the
innermost positions as
shown.
4
Make sure the screws on the pedestal align with
the holes in the retainers, then install 4 screws at
each corner to securely attach the appliance to the
pedestal.
NOTE: If the screws are not installed properly, noise
and vibration may result.
Move the appliance to the desired location.
5
Loosen the locknuts on all 4 leveling feet of the
pedestal until you can turn them with the wrench.
Turn clockwise to raise or counterclockwise to lower
until the pedestal is level and all 4 feet are solidly
against the floor.
Raise
6
Securely tighten all locknuts by hand.
NOTE: Noise and vibration may result if locknuts are not
tightened.
Be sure to connect the appliances to all water, power,
or gas lines and draining or venting connections before
operation.
If there is excessive vibration during the first operation
after installation, slightly adjust the leveling feet.
For dryer
For washer/combo
Lower
Locknut