Air Dry - LG WF-T1202TP Owner's Manual

14
F
unction of each Button
WATER TEMPERATURE
BUTTON (OPTION)
• Use to select Water
Temperature.
Pressing the button allows
you to select COLD
WARM (HOT&COLD)
HOT COLD
respectively.
Default setting is COLD.

AIR DRY

• This button is used for air-drying of your
laundry.
• Air dry selections light up in sequence as
follows.
30min. 1hr.
button is pushed.
NOTE
* For optimizing the washing algorithm, the displaying time may be changed during washing-increased by
8minutes at maximum and decreased by 4 minutes at maximum.
* If the Detergent quantity is put more than the standard, for increasing the rinsing performance, it automatically
adds rinsing, and the remaining time may be increased.
* The standard detected by the sensor changing the algorithm is set by the normal standard. It may not be same to
the washing habit of a specific user. So, it does not matter that the user uses it according to her/his washing habit.
* The sensor for a Detergent quantity is designed to detect based on a synthetic Detergent powder. If you put a
liquid one or a natural one or too much bleaching agent, the detecting ability of the sensor may be decreased.
WATER LEVEL BUTTON
(INDICATION OF DETERGENT AMOUNT)
• Use to adjust the WATER LEVEL as required. The
appropriate amount of Detergent is shown next to the
WATER LEVEL in the WATER-DETERGENT diagram
• WATER LEVEL is automatically selected for FUZZY
(normal) program.
The following settings are indicated as the button is pushed
LARGE LARGE . EX-LARGE
SMALL SMALL MEDIUM
MEDIUM LARGE
DELAY START (RESERVATION) BUTTON
2hr. 30min. as the
EX-LARGE
MEDIUM
LARGE
• Use to set a delayed finishing time.
• The time increases when the button is
pushed.
• The following settings are indicated as
the button is pushed 3
...11 12 14 16
48 3 HOUR.
• To cancel delay time, turn the power
switch off.
(refer to page 24)
TIME LEFT, DELAY START
(RESERVATION), ALARM INDICATION
• Time left - During operation, the remaining time
is indicated.
• DELAY START INDICATION
(RESERVATION) - When DELAY START
(RESERVATION) program is selected, it
indicates the finishing time. (RES.=DELAY)
• Alarm indication -When an error occurs, an error
message appears to indicate the abnormality.
For example, indicates that the lid is open.
WASH. RINSE. SPIN BUTTON
• Use when wash, rinse, spin
time need to be adjusted.
• The time increases when the
button is pressed .
• If adjustments are needed
4 5
during the wash, press the
...46
[start/pause] button before
making any changes.
• When the button is pressed
during washing, the remaining
time is displayed.