Page 1
• sophisticated • inspiring 800053 APPROVED FOR USE IN DAMP LOCATIONS allen + roth ® is a registered trademark ITEM #0970865 of LF, LLC. All Rights Reserved. 0970866 VANITY LIGHT MODEL #VBL9-16BNK VBL9-24GD Français p. 9 Español p. 17...
PACKAGE CONTENTS PART DESCRIPTION QUANTITY Fixture Mounting Plate (preassembled to fixture (A)) Mounting Plate Screw (preassembled to fixture (A)) HARDWARE CONTENTS (shown actual size) Wire Machine Connector Screw Qty. 3 Qty. 2 SAFETY INFORMATION READ AND SAVE THESE INSTRUCTIONS. DANGER •...
Page 3
SAFETY INFORMATION • DO NOT damage or cut the wire insulation (covering) during installation of fixture. DO NOT permit wires to contact any surface having a sharp edge. To do so may damage or cut the wire insulation, which could cause serious injury or death from electrical shock. WARNING •...
Page 4
PREPARATION Before beginning assembly of product, make sure all parts are present. Compare parts with package contents list and hardware contents list. If any part is missing or damaged, do not attempt to assemble the product. Estimated Assembly Time: 15 minutes Tools Required for Assembly (not included): Flathead Screwdriver, Phillips Screwdriver, Wire Strippers, Pliers, Wire Cutters, Safety Glasses, Stepladder, Electrical Tape Helpful Tools (not included): A/C Tester Light, Do-It-Yourself Guide, Soft Cloth, Level...
Page 5
ASSEMBLY INSTRUCTIONS Remove mounting plate (B) from fixture (A) by removing mounting plate screws (C) from the fixture (A). Save mounting plate screws (C) for later use. Attach mounting plate (B) to outlet box (not included) using existing washers and outlet box screws or the machine screws (BB).
Page 6
ASSEMBLY INSTRUCTIONS Prepare wires by stripping 3/4 in. of insulation WHITE from wire ends using wire strippers (not included). Connect WHITE wire from fixture (A) to WHITE wire from outlet box using existing wire connector or wire connector (AA). Connect BLACK wire BLACK from fixture (A) to BLACK wire from outlet box using existing wire connector or wire connector...
ASSEMBLY INSTRUCTIONS 7. Attach fixture (A) to mounting plate (B) using the mounting plate screws (C) previously removed (Step 3, Page 5). NOTE: Before tightening mounting plate screws (C) completely, use level (not included) to check fixture (A) -- adjust if necessary. Restore power and test fixture (A).
CARE AND MAINTENANCE • Shut off main power supply. Wipe with soft cloth or use window cleaner. Do not use an abrasive cleaner. TROUBLESHOOTING WARNING: Before beginning work, shut off the power supply to avoid electrical shock. PROBLEM POSSIBLE CAUSE CORRECTIVE ACTION 1.