Table of Contents
Advertisement
Note: In some mono models, when the input jacks
on the front panel and back panel are connected to
external equipments at the same time, the input
jacks on the front panel have priority over the
input jacks on the back panel of the TV.
Connecting the S-VHS VCR
(some models)
1. Connect the S-VHS output jack of the VCR to the
S-VIDEO jack on the side or back of TV.
2. Connect the audio/video output jacks of the VCR
to the IN 2(A/V) jacks on the front or side of TV.
3. Press the TV/VIDEO button to select
4. Press the PLAY button on the VCR.
The video playback is visible on the TV screen.
VCR Recording
(some models)
1. Connect the audio/video input jacks of the
Antenna Connections
Connecting an Outdoor Antenna
For the best reception, we recommend you use an
outdoor antenna.
Severely weathered antennas and antenna cables
can reduce the signal quality. Before connecting it,
necessarily inspect them. Any service center can
explain the various outdoor antennas available to
you.
300 Ohm Flat Wire
1. Connect the 300 ohm flat wire to screws on the
300 ohm to 75 ohm adapter.
2. Push the end of 300 ohm to 75 ohm adapter
Connecting DVD player (some models)
• Connect component DVD inputs to Y, P
and audio IN to audio(L/R) ports.
• Note: This TV is programmed to remember
which mode it was last set to, even if you turn the
TV off.
1.How to connect
TV INPUT
DV D OUTPUT
2. Select the program number on the TV.
3. Set the recording VCR to record.
Recording a program from con-
necked other equipment
(some models)
1. Connect the output jacks of the playback VCR
2. Connect the input jacks of the recording VCR to
3. Press the TV/VIDEO button to select
S-VIDEO
.
4. Press the PLAY button on the playback VCR
75 Ohm Coaxial Cable
1. Connect the 75 ohm coaxial cable directly to
Connecting a CATV Cable
If you subscribe to a CATV system, change the
antenna connection as described below.
1. Remove the 300 to 75 ohm adapter or the
2. Connect the CATV cable (75 ohm coaxial
, P
(480i)
2.How to use
B
R
• Turn the set on and press the TV/VIDEO button
on the remote control or TV/VIDEO button on the
front panel to select
•Try this after turning on the DVD set.
Y
P
P
B
R
Cb
Cr
Y
B -Y
R -Y
Y
Pb
Y
Pr
P
Y
P
B
R
9
recording VCR to the OUT (A/V) jacks on the back.
to the IN 1(A/V) jacks on the side or back of TV.
the OUT (A/V) jacks on the back of TV.
or
.
VIDEO
If you connect it to the IN 2 (A/V) jacks on the
side of TV, you should select
and set the recording VCR to record.
into 75 ohm antenna jack.
the antenna jack.
cable from the set if attached.
cable) to the 75 ohm antenna jack.
COMPONENT
VIDEO1
VIDEO2
.
.
Advertisement
Table of Contents
