Table of Contents
Advertisement
Installing the Speakers on the Half Tallboy Stand
* Front Speakers(Method 2)
1. Connect the speakers with the partition-stand as shown.
2. Insert two screws (5*15, For connecting Speakers & Partition-
Stand) clockwise into the hole marked using a screwdriver as
shown in the illustration.
!
CAUTION :
When you use a torque screwdriver, be
careful not to put excessive force. Otherwise, it runs
idle or can be damaged. (torque screwdriver- below 15
)
kg.f.cm
.
3. This is the appearance after the speaker is installed.
Installing the Speakers on the Tallboy Stand
* Surround Speakers
1. Turn the Stand Base upside-down and connect it to the Stand.
2. Insert three screws (5*15, For connecting Stand & Stand Base)
clockwise into the three holes marked using a screwdriver as shown in
the illustration.
!
CAUTION : When you use a torque screwdriver, be careful not to
put excessive force. Otherwise, it runs idle or can be damaged.
(torque screwdriver- below 15 kg.f.cm)
3. Straighten a supplied speaker wire and put in the hole on the centre of
Stand Base.
4. Connect the upper Speaker to the assembled Stand.
5. Insert another large screw (5*15, For connecting Speaker & Stand)
clockwise into the hole on the rear of the speaker using a
screwdriver.
6. This is the appearance after the speaker is installed. Follow this
steps to install other speaker.
1
2
3
1
Stand Base
Stand
3
5
2
4
Speaker
Stand
6
17
English
Advertisement
Table of Contents
