Table of Contents
Advertisement
Available languages
Available languages
en
F r e e - s t a n d i n g a p p l i a n c e
enTable of Contentse n I n s t a l l a t i o n i n s t r u c t i o n s
Using the installation
instructions
Please fold out the illustrated last page.
These installation instructions refer to
several models.
The diagrams may differ.
Installation location
A dry, well ventilated room is suitable as
an installation location. The installation
location should not be exposed to direct
sunlight and not placed near a heat
source, e.g. a cooker, radiator, etc. If
installation next to a heat source is
unavoidable, use a suitable insulating
plate or observe the following minimum
distances from the heat source:
3 cm to electric or gas cookers.
■
30 cm to an oil or coal-fired cooker.
■
The floor of the installation location must
not give way; if required, reinforce floor. If
the floor is uneven, compensate with
supports.
Distance from wall
Appliances with fitted handles must be
situated at least 525 mm from the wall
on the hinge side so that the door can
be opened by 160°.
8
160°
Installing appliances
next to each other
Fig. 3
When installing two appliances, ensure
that the refrigerator is on the left and the
freezer is on the right.
The right side panel of the refrigerator is
heated slightly. This prevents
condensation from forming between the
appliances.
Attaching spacers
Fig. 4
1. On the right side of the refrigerator
degrease the adhesive areas with
petroleum ether or spirit.
2. Stick spacers in all four corners at
a distance of 5 cm from the side
edges to ensure a minimum gap
between the appliances.
Note
You can purchase a connection set from
your dealer.
525 mm
Advertisement
Table of Contents
