Table of Contents
Advertisement
Available languages
Available languages
► 1. Slide lever
Lanyard (tether strap) connection
Safety warnings specific for use at height
Read all safety warnings and instructions. Failure to follow
the warnings and instructions may result in serious injury.
Always keep the tool tethered when working "at
1.
height". Maximum lanyard length is 2 m (6.5 ft).
The maximum permissible fall height for lanyard
(tether strap) must not exceed 2 m (6.5 ft).
2.
Use only with lanyards appropriate for this tool type
and rated for at least 7.0 kg (15.4 lbs).
Do not anchor the tool lanyard to anything on your
3.
body or on movable components. Anchor the tool
lanyard to a rigid structure that can withstand the
forces of a dropped tool.
Make sure the lanyard is properly secured at each
4.
end prior to use.
Inspect the tool and lanyard before each use for
5.
damage and proper function (including fabric and
stitching). Do not use if damaged or not functioning
properly.
Do not wrap lanyards around or allow them to come
6.
in contact with sharp or rough edges.
7.
Fasten the other end of the lanyard outside the
working area so that a falling tool is held securely.
8.
Attach the lanyard so that the tool will move away from the
operator if it falls. Dropped tools will swing on the lanyard,
which could cause injury or loss of balance.
9.
Do not use near moving parts or running machinery.
Failure to do so may result in a crush or entanglement
hazard.
10.
Do not carry the tool by the attachment device or
the lanyard.
11.
Only transfer the tool between your hands while you
are properly balanced.
12.
Do not attach lanyards to the tool in a way that keeps
guards, switches or lock-offs from operating properly.
Avoid getting tangled in the lanyard.
13.
14.
Keep lanyard away from the cutting area of the tool.
15. Use multi-action and screw gate type carabineers.
Do not use single action spring clip carabineers.
16. In the event the tool is dropped, it must be tagged
and removed from service, and should be inspected
by a Makita Factory or Authorized Service Center.
1
► 1. Hole for lanyard (tether strap)
WIRELESS ACTIVATION
FUNCTION
What you can do with the wireless
activation function
The wireless activation function enables clean and com-
fortable operation. By connecting a supported vacuum
cleaner to the tool, you can run the vacuum cleaner
automatically along with the switch operation of the tool.
To use the wireless activation function, prepare following items:
•
A wireless unit (optional accessory)
•
A vacuum cleaner which supports the wireless
activation function
The overview of the wireless activation function setting
is as follows. Refer to each section for detail procedures.
1.
Installing the wireless unit
2.
Tool registration for the vacuum cleaner
3.
Starting the wireless activation function
15 ENGLISH
1
Advertisement
Table of Contents
