Table of Contents
Advertisement
11
Timers and clock
11.1
Sleeptimer
With the sleep timer, you can set the TV to switch to standby
automatically after a preset time.
To set the sleep timer . . .
1 - Press and select Setup and press OK.
2 - Select TV settings > General settings > Sleep timer.
With the slider bar you can set the time to up to 180 minutes in
increments of 5 minutes. If set to 0 mins, the sleep timer is
switched off. You can always switch off your TV earlier or reset
the time during the countdown.
3 - Press , repeatedly if necessary, to close the menu.
11.2
Clock
To know what time it is, press TV GUIDE to find the time in
the TV guide.
In some countries, digital broadcasts do not send UTC -
Coordinated Universal Time information. The daylight saving
change might be ignored and the TV might show an incorrect
time.
Correct the TV clock
1 - Press and select Setup and press OK.
2 - Select TV settings > General settings > Clock > Auto
clock mode and select Country dependent.
3 - Select Daylight saving and select the appropriate setting.
4 - Press , repeatedly if necessary, to close the menu.
Set the TV clock manually
1 - Press and select Setup and press OK.
2 - Select TV settings > General settings > Clock > Auto
clock mode and select Manual.
3 - Select Date and Time to adjust.
4 - Press , repeatedly if necessary, to close the menu.
Change the time zone
In countries with clock transmission data, you can change the
time zone.
Step 1 - Select the correct country.
1 - Press and select Setup and press OK.
2 - Select Search for channels > Re-install channels and
press OK.
3 - Select Australia or New Zealand and press OK.
Step 2 - Set the time zone.
1 - Press and select Setup and press OK.
2 - Select TV settings > General settings > Clock > Auto
clock mode and select Automatic or Country dependent.
3 - Press to go back to the Clock menu and select Time
zone.
4 - Select your time zone, then press OK.
11.3
Switch off timer
If you do not press a key on the remote control after a preset
time, or if the TV receives no input signal nor remote control
commands for 10 minutes, the TV switches off automatically to
save energy.
If you use the TV as a monitor or use a digital receiver to watch
TV (a Set-top box - STB) and you do not use the remote
control of the TV, you should deactivate the automatic switch
off.
To deactivate the Switch off timer . . .
1 - Press and select Setup and press OK.
2 - Select TV settings > General settings > Switch off timer
and set the slider bar to Off.
3 - Press , repeatedly if necessary, to close the menu.
For more information on environmentally friendly TV settings,
press
Keywords and look up Eco settings.
36
Advertisement
Table of Contents
