Table of Contents
Advertisement
Note
•
Make sure that the picture and audio formats are
supported by your home theater (see 'File formats' on
page 35).
Radio
Listen to FM radio on your home theater, and
store up to 40 radio stations.
Note
•
AM and digital radio are not supported.
•
If no stereo signal is detected, you are prompted to
install the radio stations again.
1
Connect the FM antenna to the
ANTENNA FM 75
theater.
•
For the best reception, place the
antenna away from your TV or other
sources of radiation.
2
Press Source buttons repeatedly until
RADIO appears on the display panel.
» If you have already installed the radio
stations, the last channel that you
listened to is played.
» If you have not installed any radio
stations, the message AUTO
INSTALL...PRESS PLAY appears on
the display panel. Press
3
Use the remote control to listen or to
change radio stations.
Play buttons
Button
Action
/
Select a preset radio station.
or
Alphanumeric
buttons
EN
22
on your home
(Play).
Button
Action
Navigation
Left/Right: Search for a radio
buttons
station.
Up/Down: Fine tune a radio
frequency.
Press to stop the installation of
radio stations.
BACK
Press and hold to erase the
preset radio station.
OPTIONS
Manual:
1) Press
2) Press
3) Press
Automatic: Press and hold for
three seconds to reinstall the
radio stations.
SUBTITLE
Toggle between the stereo
and mono sounds.
Tuning grid
In some countries, you can toggle the FM tuning
grid between 50 kHz and 100 kHz. When you
switch the tuning grid, all preset radio stations
are erased.
1
Press Source buttons repeatedly until
RADIO appears on the display panel.
2
Press .
3
Press and hold
50 kHz or 100 kHz.
MP3 player
Connect a MP3 player to play audio files.
What you need
•
An MP3 player.
•
A 3.5mm stereo audio cable.
1
Using the 3.5mm or 6.5mm stereo audio
cable, connect the MP3 player to the
OPTIONS.
/
to select your
preset.
OPTIONS again
to store the radio station.
(Play) to toggle between
Advertisement
Table of Contents
