2.7 POWER SUPPLY
input Voltage Range
The monitor shall operate within specification over the range of 90 to 265 VAC power supply.
Input Frequency Range
Input power frequency range shall be from 47.5 to 63 Hz over the specified input
Quick specification review
Inrush current @ cold start
Total output power:
Withstanding voltage :
Leakage current :
220.127.116.11 Meet VESA DPMS proposal
The monitor must comply with the Microsoft On Now specification, with a minimum of three power
management states, as defined by the VESA DPMS document. The front panel of the monitor must
appropriately display the DPMS state, For example:
DPMS ON :
DPMS OFF :
DC power off
Power SW off
Power saving states are measured with speakers attached but not worked.
The recovery time from stand by /suspend/off mode to on mode is 3 seconds maximun.
1.2A (max) at 90VAC input and full load ,
0.6A (max) at 264 VAC input and full load.
30A(0-peak)@ 110Vac ,50A(0-peak) @ 220Vac
(measured when switched off for at least 10 mins.)
The power LED is Green
The power LED is Amber
48 Watt max.
1.5Kvac or 2.2KVdc for 1 minute.
< 0.25mA/100Vac , <3.5mA/230Vac
80% min. @115V/230VAC, maximum load.
Dark (DC power off)
Amber (DC power on)