Warranty And Service - Nax Power Products NAX 2000S Manual

With a drive
Table of Contents

Advertisement

TROUBLESHOOTING
Problem
The device
Spark plug flooded or damaged.
does not start
Interruption in ignition system
or contaminated fuel insert.
Engine fires
Clogged fuel line, no fuel or old fuel.
unevenly
Water, oil or dirt in the fuel system.
Oil flooded carburettor after tilting the
Badly adjusted brake cable.
The engine
goes out
The engine is
Muffler flooded with oil after tilting the
smoking
Knife adapter damaged.
Excessive
Crooked motor shaft (after impact).
vibration.
Loose assembly of components.
The mower
Inverted or worn cutting knife.
does not
throw grass in
Dirty lawn mower chassis.
the bin
A dirty or overfilled basket.
Worn or damaged drive belt.
Wheel drive
not working
(drive
Incorrectly adjusted drive cable.
version)
Worn drive protection mechanism.

WARRANTY AND SERVICE

The product purchased by you is intended for amateur (hobby) use only. If the equipment is used for other purposes
(commercial, professional), it will lose the guarantor's liability for the purchased equipment. You can find information on the
warranty and the NAX service network in the attached warranty card.
Remember that the machine should be cleaned after each use. Keeping the equipment clean will ensure long-term and
reliable operation. Cleaning, maintenance and periodic inspections are not repairs. Authorized NAC services may perform
these activities as part of a paid service.
Possible cause
Low fuel.
Contaminated air filter.
Low quality fuel.
mower to the side.
Dirty air filter.
mower to the side.
The grass is too high.
Wet grass.
Engine speed too low.
Cut grass lying down.
Solution
Check the fuel level and add fuel if necessary.
Check, clean or replace the spark plug.
Have the gardening equipment service repaired, it is best
to entrust the mower to an authorized service center.
Replace or wash the filter in soapy water and gently soak
in engine oil.
Remove fuel and refuel the mower with high-quality fuel.
Clean the fuel line, check fuel delivery, add fresh fuel.
Drain the carburettor with the fuel sink screw and top up
with fresh mixture.
Clean the carburettor from oil.
Make the appropriate adjustment.
Replace the filter.
Top up oil and start the mower for 15 minutes, the oil will
burn itself.
Replace it.
Stop the engine immediately and remove the spark plug
cap. Tighten all screws and make other appropriate
repairs. If the vibration does not disappear, entrust the
repair to an authorized service center.
Mow twice.
Do not mow.
Insert the cutting knife correctly or replace it.
Clean the mower chassis.
Empty and clean the basket.
Adjust the turnover at the authorized service center.
Replace the wheel drive belt.
Clean the transmission mechanism.
Adjust the drive cable.
Replace the gear.
25

Advertisement

Table of Contents
loading

Related Products for Nax Power Products NAX 2000S

Table of Contents