Before Using The Appliance For The First Time - Bosch WTW87560GB Installation And Operating Instructions Manual

Installing and connecting the appliance
en
The appliance is only connected to a
■
source of alternating current via a
nationally recognized and grounded
outlet that has been correctly
installed.
The mains plug and the grounded
■
socket match and the earthing
system has been correctly installed.
The cross section of the cable is
■
sufficiently large enough.
The mains plug is accessible at all
■
times.
If using a residual current circuit
■
breaker, only use one that bears the
following mark: z. The presence of
this mark is the only way to be sure
that it fulfils all the applicable
regulations.
:
Warning
Risk of electric shock/fire/material
damage/damage to the appliance!
If the appliance's mains cable is altered
or damaged, this may result in electric
shock, short circuiting or fire due to
overheating.
The mains cable must not be kinked,
crushed or altered, and must not come
into contact with any heat sources.
:
Warning
Risk of fire/material damage/damage
to the appliance!
The use of extension cords or power
strips may result in fire due to
overheating or short circuiting.
Connect the appliance directly to an
earthed socket that has been correctly
installed. Do not use extension cords,
power strips or multi-way couplers.
:
Warning
Risk of injury!
If the hoses and mains cables are not
correctly routed, they may constitute a
tripping hazard, which may result in
injury.
Route hoses and cables such that they
do not constitute a tripping hazard.
14
Connect the appliance as follows:
You can change the condensation
1.
drain if you wish. ~ Page 31
Plug the appliance's mains plug into
2.
the designated socket.
Check that the mains plug is in
3.
securely.
Your appliance is now ready to use.
If in doubt, have your appliance
Note: .
connected by a qualified professional.
Before using the appliance for
the first time
Before you switch on the appliance:
Check that there is no visible damage to
the appliance. Do not operate the
appliance if it is damaged. Should you
have any problems, please contact your
specialist dealer or our customer
service.
Once the appliance has been
Note: .
properly installed and connected, it is
ready to use. No further steps are
necessary.