WLC-100M Wireless ISA Module complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
Page 3
or transmitter This device is intended only for OEM integrators under the following conditions: The antenna must be installed such that 20 cm is maintained between the antenna and users. For laptop installations, the antenna must be installed to ensure that the proper spacing is maintained in the event the users places the device in their lap during use (i.e.
Page 4
device. Service Center in U.S.A Company Name : D-Link Corporation. Company Address: 53 Discovery Drive Irvine, CA 92618, USA Tel: (949) 788-0805 - 3 -...
IEEE 802.11b standard offering a data rate of 11Mbps in a wireless LAN environment. WLC-100M is designed for Printer Server series, IP Camera series and Internet Video Server gives you wireless access the web and network resource without the wire.
4. Hardware Installation The following sections in this chapter describe how to install WLC-100M Module 4.1. Installation Overview WLC-100M wireless module is design for Printer Server series, IP Camera series and Internet Video Server only. 4.1.1. For Printer Server series...
4.2. Safety Recommendations The safety guidelines are as follows: Keep the board area clear and dust-free before, during, and after installation. Keep tools away from walk areas where you and others could fall over them. Do not wear loose clothing or jewelry, such as earrings, bracelets, or chains, that could get caught in the board.
Page 9
Remove the WLC-100M module from its protective packaging. Avoiding Electrostatic Discharge Before you install the WLC-100M module, ground yourself by touching a piece of metal to avoid electrostatic discharge (ESD). You should also take the following precautions to prevent damage to the...