Advertisement
You can connect your oven to the system means of a terminal board. Refer
to above information for the minimal cable sections and the calibration of the
protective elements according to the connection.
If the appliance is installed with a junction box, an omnipolar circuit breaker
- with a minimum contact opening of 3mm - should be installed between the
appliance and the mains.
Power cable supply connection to the electrical mains:
We recommend you use a power supply cable which is long enough to allow
you to take the oven out of its recess in the event of maintenance operations
(only use HAR - H 05 - RRF quality cables fitted with a plug conforming to
the regulations in force.
The plug must be accessible at all times.
Unplug the appliance before all operations, even when replacing the
oven lamp. Using the appliance without correct earthing is highly
dangerous.
! After connecting the appliance to the flexible cable, tighten all the
screws on the terminal board.
PLEASE PHONE US TO REGISTER YOUR APPLIANCE AND ACTIVATE YOUR PARTS GUARANTEE ON 08448 24 24 24
APPLIANCE SPECIFICATIONS
width 43.5 cm
height 32,4 cm
Dimensions*
depth 41.5 cm
Volume*
59 l
width 45.5 cm
height 32,4 cm
Dimensions**
depth 41.5 cm
Volume**
62 l
voltage: 230 - 240 V~ 50/60 Hz
Electrical
(see data plate)
connections
maximum power absorbed
2800-3000 W
EU Directive no 65/2014
supplementing Directive 2010/30/EU.
EU Regulation no 66/2014
implementing Directive 2009/125/EC.
Standard EN 60350-1
ENERGY
Standard EN 50564
LABEL e
ECODESIGN
Energy consumption for Natural
convection - heating mode:
Convection mode
Declared energy consuption for Forced
convection Class - heating mode:
Baking
This appliance conforms to the
following European Economic
Community directives: 2006/95/EC
dated 12/12/06 (Low Voltage) and
subsequent amendments -
2004/108/EC dated 03/05/89
(Electromagnetic Compatibility) and
subsequent amendments -
93/68/EEC dated 22/07/93 and
subsequent amendment.
2012/19EU and subsequent amendment
- 1275/2008 standby/off mode.
* Only for models with drawn rails.
** Only for models with wire rails.
GB
5
Advertisement
