Advertisement

Quick Links

ZI-5990
High Pressure Cleaner
Operator Manual

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the ZI-5990 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Zico ZI-5990

  • Page 1 ZI-5990 High Pressure Cleaner Operator Manual...
  • Page 2: Safety Regulations

    BEFORE OPERATING THIS APPLIANCE PLEASE READ THESE INSTRUCTIONS CAREFULLY OVERVIEW Item Description Water inlet On/off switch High pressure washer Soap bottle Water outlet (backside) Mobile adapter bracket with wheel Adjustable Spray Wand APPLICATION THE PORTABLE PRESSURE WASHING MACHINE is a highly specialized multifunctional machine with exceptionally reliable safety assurance, which may be used to wash and clean cars, bikes and other outdoor equipment or garden patios, green houses etc.
  • Page 3 WARNING: Children should be supervised to ensure that they do not play with the machine. WARNING: The electrical supply connection shall be made by a qualified person and comply with IEC 60364-1. The electric supply to this machine should include either a residual current device that will interrupt the supply if the leakage current to earth exceeds 30 mA for 30 ms or a device that will prove the earth circuit.
  • Page 4 The machine is not intended to be connected to the potable water mains. WARNING: To ensure the machine safety, please only use original spare parts (including nozzle) from the manufacturer or approved by the manufacturer. Do not use the machine before you changed them if they are damaged.
  • Page 5 damaged. Inadequate extension cords can be dangerous. Do not abuse extension cord and do not yank on any cord to disconnect. Keep cord away from heat and sharp edges. Always disconnect the extension cord from the receptacle before disconnecting the machine from the extension cord. WARNING: To reduce the risk of electrocution, don’t start and run the machine in the rain or storm.
  • Page 6: Adjustable Spray Nozzle

    least 5 M long. Do not use the pipe if the pipe is damaged. If you want connect this machine to portable water mains, you must install a backflow preventer in the water pipe to prevent dirty water flow back to the drinking water system. The backflow preventer shall comply with EN 60335-2-79 ANNEX AA.
  • Page 7: Using Detergent

    Please make sure the trigger released and there is not any water spraying. then turn the rear part of spray nozzle clockwise ( fig 3). Squeeze the trigger, the gun will spray water with low pressure. CAUTION: Selection of high or low pressure by turning action. The selection of the pressure must be carried out with the gun in closed position.
  • Page 8: Cleaning Pin Instruction

    CLEANING PIN INSTRUCTION • Using included tip cleaner, or an unfolded paper clip, insert wire into the nozzle hole and move back and forth until debris is dislodged. • Remove additional debris by back-flushing water through the nozzle. To do this, place end of a garden hose ( with water running ) to the end of nozzle for 30-60 seconds.
  • Page 9: Major Technical Data

    MAJOR TECHNICAL DATA 11MPa(110bar) Working pressure 5.7 l/min Working flow rate 0.4MPa(4 bar) Max. pressure water supply 1.8 Kw Motor Capacity 240V~50Hz Power Supply Voltage 50 ℃ Max Water Temperature 18 kgs Weight 82x 38x34cm Dimensions...
  • Page 10 POSSIBLE PROBLEM AND SOLUTION: FAULT PROBABLE CAUSE REPAIR When Plug is not well connected or electric Check plug, socket switched on socket is faulty the machine will not start The main voltage is insufficient, Check that the main voltage is working lower than minimum requirement adequate.
  • Page 11: Water Inlet

    INSTALLATION, ELECTRICAL AND WATER CONNECTIONS 1. PRESSURE CLEANER 2. WATER SUPPLY HOSE(not include) 3. WATER CONNECTION 4. WATER INLET 5. HIGH PRESSURE TUBE 6. HIGH-PRESSURE, WATER OUTLET 7. SPRAY GUN 8. POWER SUPPLY : Given continuous machines development the Note company reserves the right to amend machines specifications without notice.
  • Page 12 For safety use, make sure a three-month clean the machine. Before working, make sure inspect the filter and the nozzle, make sure there is no impurity. After working, make sure there is no water in the pump and the hose. If the machine need to be repaired in the guarantee period, please return the machine to the shop.

Table of Contents