GE OPAL01GEPKT Owner's Manual page 13

Side Tank Accessory
NOTE: The Side Tank Accessory is only included with model number
OPAL01GEPKT.
6. P lace Opal Side Tank against the Opal Nugget Ice Maker so that the Side Tank magnets attach to the ice maker.
Your Opal Side Tank can be installed on either side of your Opal Nugget Ice Maker.
NOTE: Care should be taken to connect the correct drain tube to the Opal Side Tank. Drain tube (B) should
always be connected to the Side Tank whether it is installed on the left or right side of the Opal Nugget Ice
Maker.
Drain tube B
attached to
the side tank
7. Remove Opal Side Tank's clear reservoir from i ts base.
8. U nscrew Opal Side Tank's cap from the reservoir. F ill the clear reservoir with water.
9. R eplace Opal Side Tank's cap. Ensure the cap is clean when installing.
10. C arefully flip over Opal Side Tank's reservoir and place in the base. Water should start flowing into the Opal
Nugget Ice Maker and bubbles in the Opal Side Tank will appear periodically during the time water is flowing to the
ice maker.
NOTE: If water does not appear to flow into the ice maker, please check for the following:
- T here may be bubbles in drain tube (B) connecting the Side Tank to the Opal.
- Tube (B) is not lying flat.
If either of the above issues are present, adjust tube (B) to allow the water to flow.
11. Fill Opal Nugget Ice Maker's reservoir.
12. Plug in Opal Nugget Ice Maker, and begin making ice.
49-1000418 Rev. 6
Drain tube B
attached to
the side tank
13