Whispbar K089 Fitting Instructions For Basic Carrier page 8

EN
Fitting Kit
K089W
Place crossbar on vehicle. Minimum
recommended spacing between the bars is
700mm (27 1/2") (unless otherwise stated).
Please check the rear of this manual for
information relating specifically to your
vehicle.
Adjust crossbar in or out to suit vehicle.
Refer to the crossbar instructions for
crossbar adjustment.
Ensure that the crossbar is adjusted evenly
at both ends.
Ensure the clamp pin is inserted into the
fixed point and the clamp sits flat to the
body side.
Repeat for all four positions.
Refit rubber seal over the clamp.
Tighten adjusting screw to 5 Nm (3.7 ft lb).
8